Vestil SCTAB-2500-2040-FP handleiding
Handleiding
Je bekijkt pagina 3 van 14
Rev. 3/26/2014 SCTAB, manual.doc
Copyright 2014 Vestil Manufacturing Co.
Page 3 of 14
Safety Recommendations:
We strive to identify foreseeable hazards associated with the use of our products. However, material handling
is inherently dangerous and no manual can address every risk. The end-user ultimately is responsible for
exercising sound judgment at all times.
Material handling is dangerous. Improper or careless operation might result in serious personal
injuries sustained by the operator and bystanders. Always apply material handling techniques learned during
training and use the product properly:
Failure to read and understand the entire manual before assembling, using or servicing the product
constitutes misuse. Read the manual to refresh your understanding of proper use and maintenance
procedures as necessary.
DO NOT attempt to lift a load that weighs more than the maximum rated load of your table. The rated load
(capacity) of your pallet handler appears on label 287 as shown in “Label placement diagram” on p. 12. (Also
see product specifications table on p. 2. If the maximum rated load displayed on label 287 differs from
information in the table on p. 2, the number shown on the label should be deemed to be correct).
DO NOT allow people to stand or sit on either the table or the load.
Stand clear of the table while raising or lowering it.
Keep clear of pinch points! As the deck rises and lowers, pinch points occur between the leg weldments.
NEVER reach into or put any part of your body inside the scissors mechanism UNTIL the table is supported by
maintenance stops.
DO NOT install the table outdoors or in corrosive environments. ONLY install the table on compacted, improved
surfaces capable of supporting the combined weight of the table and a full capacity load.
DO NOT perform maintenance on this table UNLESS it is unloaded and maintenance stops are in place. If the
table requires repairs, ONLY install manufacturer-approved replacement parts.
DO NOT alter the pressure relief valve setting!
ALWAYS center and evenly distribute loads on the table. Secure loads to the table if they are likely to roll or
slide off of the table.
ALWAYS observe the table while raising and lowering the table. The table should rise smoothly and evenly from
side-to-side. Watch for binding or jerky movement and listen for unusual noises. Tag the unit "Out of order" and
do not use it if you observe anything abnormal.
DO NOT use the table unless it is in normal operating condition. Inspect the unit before each use according to
the inspection instructions on p. 11 to determine whether the unit is functioning normally. DO NOT use the
table unless it passes every part of the inspection or until it is restored to normal operating condition.
Always watch the load carefully while raising and lowering the deck.
DO NOT continue to pump the foot pedal if the table is fully elevated (does not continue to rise).
Before leaving the table unattended, unload it and relieve hydraulic pressure by pressing the release lever and
holding it until the table is fully lowered.
DO NOT use the cart UNLESS all labels are in place and readable (see “Label placement diagram” on p. 12).
DO NOT modify this table in any way. Modifying the table automatically voids the limited warranty and might
make it unsafe to use.
Proper use and maintenance are essential for this product to function properly.
Always use this product in accordance with the instructions in this manual and consistent with any training
relevant to machines, devices, etc. used in conjunction with this product.
Periodically lubricate moving parts.
Keep the product clean & dry.
Only use approved replacement parts. To order replacement or spare parts for this equipment, contact the
factory.
Bekijk gratis de handleiding van Vestil SCTAB-2500-2040-FP, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Vestil |
| Model | SCTAB-2500-2040-FP |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 3059 MB |
