Vestil RR-65-25 handleiding
Handleiding
Je bekijkt pagina 5 van 5
Before installing dock bumpers, consider the following factors:
a. Dock seals and/or dock shelters: bumpers should not interfere with seals/shelters. If there
currently are no seals or shelters, is it likely that they will be installed in the future?
b. Building siding: will the siding protrude beyond the bumper face?
c. Other building features such as conduits, plumbing lines, exterior dock traffic lights: are
additional bumpers necessary to protect these building features or surrounding areas?
Standard rubber dock bumpers:
Bumpers are provided to protect your building! Care during installation is recommended and will
protect the dock area. Standard
dock bumpers are comprised of a laminated rubber core with
steel angle pieces attached to opposite sides. These bumpers should be installed with the rubber
laminations oriented vertically. Attach bumpers to the dock wall with the edge of the inner angle
piece flush with an inside edge of the pit. The top edge of the rubber core should be flush with the
dock floor.
NOTE: Bumper effectiveness is compromised if a bumper is attached to a damaged or
unsound surface. Only attach bumpers to structurally sound surfaces!
Bumper installation procedure:
1.) Hold the inner angle piece of bumper
flush with the inside edge of a (pit)side
wall panel. The top edge of the bumper
should be flush with the dock floor.
2.) Tack weld the inner angle piece to
the edge of the pit side wall panel.
3.) Each angle piece includes 2
holes for anchoring hardware.
Anchoring hardware is necessary
to fasten the outer angle pieces
to the dock wall. . se a hammer
drill to make holes for concrete
anchors.
4.) Install the concrete
anchors. Tighten them to the
torque specified by the
anchor manufacturer.
5.) Weld the entire length of the
inner angle pieces to the (pit)
side wall panels.
The dock leveler is now ready to use.
Read the entire instruction manual before
using the leveler for the first time.
Part D: Install Dock Bumpers (Optional)
ANGLE PIECE (INNER) SHOULD
BE FLUSH WITH INSIDE EDGE OF
PIT WALL
ANGLE PIECE (OUTER): DRILL HOLES
FOR ANCHORING HARDWARE
INSIDE EDGE
OF PIT SIDE
WALL PANEL
TOP OF
RUBBER
CORE FLUSH
WITH FLOOR
RUBBER
CORE
Page 5 of 5
Bekijk gratis de handleiding van Vestil RR-65-25, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Vestil |
| Model | RR-65-25 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 848 MB |
