Vestil RR-65-25 handleiding
Handleiding
Je bekijkt pagina 2 van 5
Part B: Assemble the Wall Panels
REAR WALL PANEL (PAIR OF
BOLT HOLES AT EACH END)
LEFT SIDE
WALL PANEL
(1 PAIR OF
BOLT HOLES)
RIGHT SIDE WALL PANEL
(1 PAIR OF BOLT HOLES)
6ft. LONG FRONT
CURB WELDMENT
Wall panel installation (see diagram on following page)
1.) Set rear panel on back edge of pit floor. Rear panel has a pair of bolt holes at each end.
2.) Fasten the right and left side panels to the rear panel using the
1
/
2
" hardware included
with the panels. Align bolt holes in the side panels with bolt holes in the rear panel. Insert
bolts through the holes. Secure bolts with flat washers and lock nuts.
3.) Shim and adjust the wall panels to make the top edges flush with the finished floor.
4.) Square the side wall panels and rear panel. The rear panel must be parallel to the front
edge of the pit. Side panels must be parallel to each other. Side panels must also be
square to the rear panel and front edge.
5.) Lag the side panels and rear panel to the pit floor with anchoring hardware (not included).
6.) The temporary use of bracing to hold the panels in place while pouring concrete is
recommended. Bracing should be designed to prevent the panels from bowing, tipping, etc.
Carefully place concrete around the panels. Work the concrete to fill pockets.
7.) Double check the squareness of the wall panels while pouring and finishing the concrete.
ANCHORING PROJECTIONS
Page 2 of 5
Bekijk gratis de handleiding van Vestil RR-65-25, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Vestil |
| Model | RR-65-25 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 848 MB |
