Vestil PAIL-T handleiding
Handleiding
Je bekijkt pagina 4 van 6
TABLE OF CONTENTS Rev. 4/23/2021 PAIL-T, MANUAL
TABLE OF CONTENTS Copyright 2021 Vestil Manufacturing Corp. Page 4 of 6
USING THE PRODUCT
Do not traverse sloped ground while the truck
is loaded unless you can easily control the truck.
Always remain upslope of the truck while
traversing slopes. This product can be used as
either: 1) A standard hand truck; or 2) A pail
carrier.
1) To configure as a hand truck, deploy the
nose plate. Place a load on the nose plate.
Grasp the handle and tilt the truck back. Push
the truck and load to the destination
2) To use the device as a pail carrier, fold the
nose plate and deploy the pail carrier. Make
sure that the pail is covered with a lid, if
necessary.
RECORD OF SATISFACTORY CONDITION (THE “RECORD”)
Before putting the hand truck into service, make a detailed record of its condition. Include
observations about all features: pivot points, welds, frame elements, nose plate, pail carrier, fasteners
(anchor bolts, bolts, nuts, washers, etc.), axle, and wheels. Thoroughly photograph the unit from
multiple angles so that all features are clearly imaged. Photograph all labels applied to the product.
Describe where each label is located. Collect all photographs and writings in a single file. This file is a
record of the product in satisfactory condition. Compare the results of each inspection to this RECORD
to determine if the unit is in satisfactory condition. Do not use the product unless it is in satisfactory
condition
INSPECTIONS AND MAINTENANCE
Compare inspection results to the RECORD. Do not continue to use the product unless every
component is in SATISFACTORY CONDITION. Cosmetic changes, like damaged paint/powder coat
do not constitute changes from satisfactory condition. However, touchup paint should be applied to all
affected areas as soon as damage occurs. Contact
TECHNICAL SERVICE to order replacement
parts. Contact information is provided on the cover page of this manual.
Inspect the following at least once per month:
1. Surfaces – Check all surfaces of the product for dirt or other matter, especially fluids. Clean the
truck.
2. Hardware, fasteners – Examine hardware & fasteners (axle, bolts, nuts, pins, & clips). Replace
damaged/worn hardware.
3. Examine the frame for wear, breaks, corrosion/rust, metal fatigue, and other forms of damage (e.g.
impact damage). Pay particular attention to the nose plate and pail carrier. Before features should
be securely attached to the frame and should pivot smoothly. Closely inspect pivot points for
rusting/corrosion. Wheels must be securely attached to the axle.
4. Labels – Replace damaged labels. Replace a label if it is not easily readable from a reasonable
distance.
5. Overall structure – Examine the whole structure for rusting or metal erosion, rot, thinned regions. In
particular, examine pivot points, and ground-contacting elements. If rusting is purely superficial,
remove the rust/corrosion. Clean the affected area and apply touchup paint. If rusting, rot, or
thinning has weakened the material, contact TECHNICAL SERVICE
for advice.
Hand truck Pail carrier
Nose
plate
Pail
carrier
Bekijk gratis de handleiding van Vestil PAIL-T, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Vestil |
| Model | PAIL-T |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 1352 MB |
