Vestil LAD-FM-60-PSO handleiding
Handleiding
Je bekijkt pagina 16 van 21
TABLE OF CONTENTS Rev. 9/30/2021 LAD-FM-PSO, MANUAL
TABLE OF CONTENTS Copyright 2021 Vestil Manufacturing Co. Page 16 of 21
Step 12: Attach the limit switch (01-022-021) to the mounting lift bracket. See Step 3 on p. 11. The
limit switch is connected to a yellow electrical cord. It attaches to the mounting lift bracket via two
(2) M4 x 45mm screws. Attach the free end of the yellow cord from the limit switch to the free end of
the yellow cord from the junction box.
Step 13: Install the cable hoist. A) The hoist attaches to a formed mounting bracket (44-016-123) with 4
metric machine screws. The screws are wound into bolt holes in the bottom of the winch. Remove the
screws. Set the hoist on top of the formed bracket. Align the bolt holes in the bottom of the winch with
the bolt slots in the bracket. Install and tighten the screws. B) Connect the winch to the power source.
Plug the 3-prong adaptor at the end of the black power cord to a 115VAC power outlet. C) Twist the
red button on the handheld controller in the direction of the arrows on the button. The button should
pop up. The hoist will now respond to signals from the controller. A 3-position switch is located below
the red button on the controller. Pressing the switch forward causes the hoist spool to rotate and
cable to unwind from the hoist. Pressing the button back (and down) causes the spool to rotate in the
opposite direction which winds cable back onto the spool. Take hold of the cable hook and press the
button forward to unwind cable from the spool. Unwind approximately 10-12 feet of cable. D) Attach
the cable hook to a quick link (99-145-053). E) Feed cable to the left of the cable grabber (same side
as the bent fingers) and into the groove of pulley A. Reinstall the shoulder bolt removed during
Step
3C on p. 11.Then, seat cable into the groove of pulley B. F) Attach the quick link to the small opening
on the right side of the limit switch lever (44-016-132). G) Move the hoist to a position where the cable
is substantially vertical. Mark the floor with the locations of the anchor bolt holes in the mounting
bracket. Attach the bracket to the floor using 3/8” anchor bolts of appropriate length as selected by
your building engineer.
Pulley A
Limit switch
Rear
view
Front view
Yellow electrical cord; connect free end
to yellow cord from junction box
M4 x 45mm
screw
M4 x 45mm
screw
Attach limit
switch here
Limit switch
installed
Align holes in
bottom of hoist
with bolt slots in
mounting
bracket and
attach with
machine screws
Bolt
slot
Cable hoist
To hoist
Limit switch lever
Cable
grabber
Anchor
bolt hole
Cable hoist
mounting bracket
Cable hook
Quick
link
Bekijk gratis de handleiding van Vestil LAD-FM-60-PSO, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Vestil |
| Model | LAD-FM-60-PSO |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 6346 MB |
