Vestil JIB-HC-3 handleiding
Handleiding
Je bekijkt pagina 7 van 10
Rev. 10/17/2016 JIB-HC, MANUAL
Copyright 2016 Vestil Manufacturing Co. Page 7 of 10
Use instructions:
Before using the crane for the first time, OSHA regulations require an “Initial Inspection”. The inspection procedure is
paraphrased on p. 11-12. However, you should read the entire regulation periodically, which can be accessed through
http://www.OSHA.gov/.
To reduce the likelihood of serious personal injuries caused by improper or careless operation:
Only qualified, designated crane operators should use this device. The operating instructions in this manual
supplement safe crane and hoist operation practices learned during your training program. ALWAYS apply the safe
material handling practices learned from your training program (for example, practical operating examination) and
conform to OSHA crane operation standards (29 CFR 1910.179).
All personnel not using the crane should remain outside the operating area during use. Instruct all persons to
remain at a safe distance during operation.
DO NOT use the crane if: 1) you observe any damage to the (wall mounting) brackets or hear unusual noise during
use; 2) if you observe any warping or deformation of the boom, the brackets, the load hook or chain (or cable). Notify
your supervisor and authorized maintenance personnel if you notice anything unusual.
Proper load lifting:
Always follow the instructions provided with your hoist and trolley.
Position the trolley and hoist directly above the load. Proper loading requires the operator to position the hoist
above the center of the load. Proper positioning is diagrammed below:
Proper load centering beneath hoist and trolley
Improperly positioned loads
Connect the load to the hoist chain/cable, using appropriate rigging. Then, raise the load only as high as
necessary. Slowly direct the load to the desired location. Once the I-beam and hoist are properly centered above the
work location, lower the load and disconnect it from the hoist.
Side view
Front view
Side view
Front view
Hoist cable/chain aligned with centerline (red dashed line)
Hoist cable/chain not aligned with centerline (red dashed line)
Bekijk gratis de handleiding van Vestil JIB-HC-3, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Vestil |
| Model | JIB-HC-3 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 2200 MB |
