Vestil HSR-4860 handleiding
Handleiding
Je bekijkt pagina 4 van 6
TABLE OF CONTENTS Rev. 7/7/2021 HSR-4860 MANUAL
TABLE OF CONTENTS Copyright 2021 Vestil Manufacturing Co. Page 4 of 6
SAFETY INSTRUCTIONS
Vestil strives to identify foreseeable hazards associated with the use of its products. However, no
manual can address every conceivable risk. The most effective way to avoid injury is to exercise sound
judgment when assembling, using, inspecting, and maintaining this crane.
WARNING
Risks of serious personal injuries or death.
• Read this manual in its entirety before assembling, using, inspecting or servicing the product. Read the
manual to refresh your understanding of use, inspection, and maintenance procedures as necessary. A
copy of this manual should always be available to all persons who assemble, use, inspect and/or
maintain this device.
• DO NOT use the product if any unusual noise or movement is observed.
• ONLY use/install this rack on even, level surfaces. DO NOT use the rack UNLESS it is securely anchored
to a concrete surface capable of supporting the combined weight of the rack (~120lb.; 54.5kg) and a
full capacity load (2,000lb; 909kg).
• Inspect & maintain the rack as instructed in the INSPECTIONS & MAINTENANCE section on p. 5. Do not
use the rack unless it is in SATISFACTORY CONDITION. See RECORD OF SATISFACTORY CONDITION, p. 5.
ONLY use manufacturer-approved replacement parts.
• DO NOT remove or obscure any label. Before using the rack, confirm that all labels are in place and
easily readable. See LABELING DIAGRAM on p. 7.
• DO NOT climb on the rack.
• DO NOT apply loads weighing more than the capacity of this rack. The overall capacity of the rack is
2,000 pounds (909 kg). The capacity of each level (pair of rack arms) is 500 pounds (227kg). Do not
apply more than 500 pounds to any pair of rack arms. Load the rack from the lowest level up. Center
loads on the arm pairs. Loads should not overhang the arms by more than 12” (30cm).
• DO NOT pull or drag a loaded rack. Completely unload the rack before moving it.
• DO NOT modify the rack in any way. Modifying the rack automatically voids the LIMITED WARRANTY
(on p. 6) and might make the rack unsafe to use.
INSTALLING THE RACK
Install the rack indoors on a level, even improved surface capable of supporting the combined weight of
the rack (~120lb.; 54.5kg) and a full capacity load. The capacity of each arm pair is 500 pounds (227kg). Do
not apply more than 2,000 pounds (909kg) overall to the rack. There are 4 bolt holes in the base frame of
the rack for anchor bolts. Bolt hole location is diagrammed in ASSEMBLING THE RACK. Attach the rack to the
floor with 1/2” anchor bolts that are at least 4” long.
ASSEMBLING THE RACK
Insert the formed arms (31-014-510) into the arm receivers of the rack frame (31-514-355). Arm notches
must face upwardly when installing the arms. The notch of each arm receives the rear wall of the inclined
support. Insert an arm into the same receiver of each inclined support.
!
Arm
receiver
Notch
Inclined
support
Formed arm
Rear wall seats into notch
Complete
assembly
Arm pair
Bolt hole for
1/2” anchor
bolt)
Bekijk gratis de handleiding van Vestil HSR-4860, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Vestil |
| Model | HSR-4860 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 1390 MB |
