Vestil FMDDL-1700 handleiding
Handleiding
Je bekijkt pagina 7 van 9
9/22/2010 FMDL manual, operation instructions.doc
Drum engager pinned to top hole
of supporting mast
Use Instructions (Fork-mounted models: all but FMDL-1700)
Step 1 : Adjus t the pos itions of your lif t tr uck’s forks /tines to matc h the spacing
between the fork p ockets. Apply the operat ion procedures learned during your lift
truck training program to properly adjust fork position.
Drum
engager
supporting
mast
Drum cradle Fork
p
ocke
t
Step 2
: Mount the drum lifter on the forks of y our lift truck. Slowly drive the truck
forward until the forks contact the ends of the fork p ockets. For m odels equipped
with cam locks, the lifter must be fully and evenly supported by the floo r to keep
the cam lock open so that the forks can enter the fork pockets.
Step 3
: Connect the drum lifter to the fork truck by attaching the safety chain to the
fork carriage. Wrap th e chain around the fork carriage and then fasten the snap
hook to the chain without slack. If your lifter inc ludes a brack et attached to the
free end of the safety chain, wrap the chain around the carriage, and attach the
bracket to th e top of the carriage without slack. T he chain m ust not be able to
disconnect from the carri age without deliberate eff ort. For in stance, the ch ain
must not be able to slide free of the carriage. If different procedures are applied at
your worksite, follow those procedures instead of these directions.
The chain and cam lock assembly are essential safety-enhancing features. Use the chain to connect the
drum lifter to the carriage of your fork truck. Wrap th e chain around the carriage and fasten the fre e end to the chai n, or
the bracket to the top of the carriage, with no slack. The chain will not prevent the drum lifter from sliding off of the forks if
it is improperly connected to the fork carriage.
Slowly lower the forks to avoid damaging impacts between the floor/ground and the drum or lifter.
Step 4 Engage the selected drum with the lifter: To properly engage a 55 gallon drum, adjust the position of the d rum
engager so that it is pinne d to the top hole in the sup porting mast. To engage smaller drums, when close to the drum,
lower the carriage a s far as possible; then remove the adjustment pin, (item # 2 3 on p. 5). Lo wer or raise the eng ager
mounting link (item #29 on p. 5) mechanism so that the lower jaws are slightly below the rim of the drum. It is advisable
to have the cradle contact the drum ne ar its base. Raise the forks j ust a few inc hes off of the groun d/floor, and tilt the
mast of the fork truck forward. Drive slowly towards the selected drum until the lower jaw of the drum engager contacts
the side of the drum just beneath the lip.
Step 5 Grasp the lip of the drum
: Slowly raise the forks until the upper jaw engages the top of the drum lip. Continue to
raise the forks until the drum is elevated a few inches above the floor/ground.
Step 6 Tran sport the d rum
: Straighten the mast an d transport the drum to th e desi red unloading location. Rai se the
forks as required by conditions along the travel path.
Step 7 Rele ase the d rum
: Lower the fo rks until the d rum is just a few inches above the floo r. Tilt the fork truck ma st
forward. Slo wly lo wer the forks until t he ja ws di sengage the lip of the drum and the drum is fully su pported by t he
floor/ground.
FMDL-1700 model only:
Remove tines/forks from the forklift carriage. Set the upper mast support bracket on the top
rail of the fo rk truck carriage, in the l ocation wh ere the bottom mounting bracket of the
EG4DCM can fit into the cut-out portion of t he bottom rail of the carriage. Slide the FMDL -
1700 unit slightly to the left or the right of center, until both mounting brackets are seat firmly
on the carriage.
Upper mast support
brac
ket
Lower mast support
brac
ket
7 of 9
Bekijk gratis de handleiding van Vestil FMDDL-1700, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Vestil |
| Model | FMDDL-1700 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 3919 MB |
