Vestil FM-T-DUMP handleiding
Handleiding
Je bekijkt pagina 5 van 6
Rev. 11/6/2015 FM-T-DUMP MANUAL
Copyright 2015 Vestil Manufacturing Co. Page 5 of 6
Inspections & Maintenance:
Regular inspections and maintenance are necessary to keep the dumper in normal working condition. DO NOT use
the dumper unless it is in normal operating condition. Repair any item that is found to not be in normal operating
condition during an inspection or use. If it is not possible to repair an item, replace it before returning the dumper to
service.
Regular/Frequent: Inspect the listed components before the dumper is used for the first time and before each
subsequent use.
1. Cable: examine the cable for frays and other forms of damage (corrosion, birdcaging, etc.).
2. Frame: confirm that the frame is sound, i.e. no structural damage or deformation.
3. Safety chain, quick link, and snap hook (attached to the free end of the safety chain):
4. Labels: all labels should be readable and located on the dumper as diagrammed below. Replace all labels
that are damaged, faded, or otherwise unreadable.
5. Latch/release mechanism: Proper functioning of the latch/release mechanism;
Periodic: At least 1 time per month, inspect:
1. Fasteners (hardware):
a. Bolts, nuts, washers, pins, cotter pins;
b. Chain and snap hook.
2. Fork pockets: confirm that each pocket is structurally sound, e.g. not severely worn or corroded.
3. Welds: confirm that all welds are intact.
4. Pivot points and pivot point pins.
5. Dumper release mechanism: confirm that the release mechanism functions properly. In particular, make sure
that the chute latch releases properly when the cable is pulled and automatically reengages the upright frame
when the frame is returned to the cart-carrying position (see Step 8 on p. 4). If the mechanism does not rotate
smoothly or is really noisy when it rotates, apply grease through the 3/16 inch grease fittings.
Components of
the release mechanism include the following:
a. Release spring;
b. Upright frame
c. Latch handle;
d. Chute latch;
e. Handle pins;
f. Handle brackets;
g. Axle brackets.
6. Overall condition of frame: the structure should be clean, square and rigid, and free of rust and corrosion.
Remove dirt and debris.
Labeling diagram:
Only use the dumper if it is labeled as diagrammed below. ALL labels must be readable and undamaged. Replace all
damaged/unreadable labels.
19b
A
B: Label # 218 – Hazards of improper use.
A
B
C
A: Label 208 -- Keep clear of pinch point.
C: Label 287 – Product data label.
Bekijk gratis de handleiding van Vestil FM-T-DUMP, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Vestil |
| Model | FM-T-DUMP |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 2508 MB |
