Vestil EHLT-TL-30180-4-58 handleiding
Handleiding
Je bekijkt pagina 14 van 22
Operator’s Manual 10/23/2023 EHLT-TL MANUAL
Table of Contents Copyright 2023 Vestil Manufacturing Co. Page 14 of 22
To raise the platform without using a power supply, use a hoist with straps or chain rigging, or the forks on
a lift truck. Lift from the hinged end of the platform. Take care not to damage the aluminum perimeter toe
guard under the platform. Use the 4x4 wood dunnage to secure the base while lifting the platform.
4. Anchor the frame to the floor through the 4 mounting holes in the frame (red solid arrows in diagram
below).
5. Shim and/or grout the entire length of each base side frame to ensure that it is level and fully
supported. The entire base frame rail must be supported with no gaps in its foundation for the lift table
to function properly.
6. Have a qualified electrician make a permanent connection to the power supply.
7. Operate the lift table through several full raise and lower cycles. Verify that actuating the upper travel
limit switch (mounted on the base frame, near the power unit; blue circle in diagram above) prevents
further upward travel of the platform. Verify that pressing/actuating any part of the perimeter toe
guard switch (under the platform; green, dashed arrow in diagram above) prevents further downward
travel of the platform. DO NOT place a lift table in service if either of these devices (limit switch or
perimeter toe guard) isn’t functioning properly.
8. Check the hydraulic oil level. Both reservoirs should be filled to within 1” to 1-½” of the fill hole.
Note: The reservoir is an integral part of both scissor mechanisms. The diagram above only calls out the
reservoir of leg set 1. If oil is needed, use anti-wear hydraulic oil with a viscosity grade of 150 SUS at
100°F (ISO 32 at 40°C) or a non-synthetic automatic transmission fluid.
9. Clean up any debris or spilled oil. Verify that all of the information, safety, and warning labels are in
good, easily readable condition. See Labeling Diagram on p. 21.
Perimeter toe guard
(attached to underside
of platform)
Upper travel
limit switch
Power unit
Mounting tabs
Mounting tabs
Leg set 1
Leg set 2
Reservoir fill hole
Maintenance
prop
Maintenance
prop
Reservoir fill hole
Bekijk gratis de handleiding van Vestil EHLT-TL-30180-4-58, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Vestil |
| Model | EHLT-TL-30180-4-58 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 5647 MB |
