Vestil CYL-2-FF handleiding
Handleiding
Je bekijkt pagina 6 van 8
rev. 1/30/2017 CYL-2, MANUAL.doc
Copyright 2017 Vestil Manufacturing Corp. 6 of 8
Use Instructions:
1. Place the cylinder on the cart. Position the cylinder so that it rests firmly against the crossbars.
2. Release the ratchet to extend the strap, if necessary. To release the ratchet, pull the release lever toward the
handle and pivot the ratchet handle as far from the ratchet base is it will travel (approximately 180 degrees). By
pulling on the strap now, it will unwind from the spindle and increase the usable length. Ratchet parts are
identified in Fig. 3B below.
3. Wrap the ratchet straps around the cylinder and connect to the J-hook to the J-hook slots of the divider (see
Fig. 3B).
4. Pivot the handle back towards the base and let go of the release lever.
5. Tighten the strap against the cylinder by moving the handle towards and away from the base.
6. To remove a cylinder from the cart, release strap tension by following the procedure described in step 2
(above).
Fig. 3B: Wrap the ratchet straps around each
cylinder and slide the J-hooks into the J-hook slots
on the back of the divider..
J-hook
slot
J-hook
slot
J-hook
J-hook
Cross bar
Divider
Fork
pocket
Lifting eye
Ratchet
handle
Ratchet
base
Ratchet
release
FIG. 3A: Cylinder dolly
Ratchet
strap
Bekijk gratis de handleiding van Vestil CYL-2-FF, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Vestil |
| Model | CYL-2-FF |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 1990 MB |
