Vestil CR-144-2 handleiding
Handleiding
Je bekijkt pagina 5 van 8
Rev. 5/3/2018 CR MANUAL
Copyright 2018 Vestil Manufacturing Corp. Page 5 of 8
Installing the carpet ram:
Step 1: Remove the tines from the lift truck carriage.
Step 2: Referring to the diagram below, rotate the latch lever to the open position. Set the left side of the upper
carriage bracket on the upper carriage crossbar of your lift truck.
Step 3: Slide the upper carriage bracket along the carriage crossbar. Adjust position to allow the lower carriage
bracket to fit into the notch in the lower carriage crossbar (of the forklift). The notch is probably located at the center
of the crossbar. Next, slide the back plate to the left or right as necessary to center the carpet ram on the carriage.
Step 4: Secure the carpet ram to the lift truck carriage by closing the latch.
[NOTE: The latch lever will only rotate back to the closed position if the latch aligns with a notch in the upper
crossbar. If necessary, adjust the position of the ram until the latch aligns with a notch.]
Using the carpet ram:
Engage a roll of carpet by driving the lift truck forward and inserting the pole through the center of the roll. Drive
forward until the roll contacts the roll stop (see Exploded Views on p. 3, 4). You should see at least the yellow tip of
the pole. The carpet roll must not be longer than the pole. If the roll is too long, use another device to transport it.
Raise the forks only as high as necessary to lift the roll of carpet off of the ground and to avoid contact with
objects during transport. Always watch and listen to the ram for abnormalities during use. DO NOT leave a raised roll
unattended. Always unload the carpet ram before leaving the forklift.
Carpet ram
back plate
Lower
carriage
bracket
Upper
carriage
bracket
Upper
carriage
crossbar
(of forklift)
NOTE: The latch can be attached to either the
left or right side of the upper bracket (shown
installed on left side).
Turn latch lever to open
position (shown closed)
Set the upper carriage
bracket on the carriage
crossbar of your forklift.
Then, slide the bracket
along the carriage crossbar
until the lower carriage
bracket fits into the notch in
the lower carriage crossbar
of your forklift.
Lower
carriage
bracket
Left side
Right side
Bekijk gratis de handleiding van Vestil CR-144-2, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Vestil |
| Model | CR-144-2 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 1789 MB |
