Vestil CH-10-12 handleiding
Handleiding
Je bekijkt pagina 5 van 7
Rev. 9/13/2016 CH, MANUAL
Copyright 2016 Vestil Manufacturing Co. Page 5 of 7
Step 2: Secure the bracket weldment so that the coil
retainer is perpendicular to the hook jaw as shown.
Tighten the bolt, lock nut, so that the bracket weldment
is securely attached to the frame.
Step 4: Move the coil hook into position above the load and insert the jaw of the coil
hook through the center of the coil.
The hoist chain/cable should be straight up-and-down when the
hook is connected to a coil. Deflection from vertical will cause the load to swing
when lifted. A swinging load might cause injuries.
Step 5: Confirm that the load will remain stable when lifted. Grasp the hook by the.
Raise the load just a few inches above the ground. If the load slides, return it to the
ground. Then, reposition the hook to prevent sliding. DO NOT proceed to the next
step until the load is properly stabilized i.e. does not slide when lifted.
Step 6: Grasp the handle and lift the load to approximately waist height. Move the
load to the desired location.
Review all hazard safety messages on p.5 and apply the following:
1. NEVER lift material over yourself or other people.
2. Keep your hands away from the coil while raising, lowering and/or moving it. ONLY grasp the handle to
stabilize the load.
3. Always grasp the handle and walk at arm’s length to the side of the load. Make sure that your clothing,
feet, and all other parts of your body stay out of contact with the load.
4. If you are using a motorized trolley to move a coil, DO NOT push or pull on the handle. Allow the trolley
to supply all movement. Hold onto the handle ONLY to stabilize the load.
5. If you are using a manual trolley, grasp the handle with one hand. Push or pull the handle to move the
trolley.
Step 7: Make sure that the hook is not swinging or rotating; then slowly lower the load to the ground. DO NOT
remove the load from the hook until you immobilize it to prevent the coil from rolling or falling over. Once the load
is immobilized, disengage the hook from the load.
Coil
retainer
Bracket
weldment
Bolt &
lock nut
Perpendicular
Step 3: Connect the coil hook to the hoist. Use a
hoist with a (latching) safety hook to prevent
accidental detachment from the hoist.
Safety
Hook
Safety latch
Jaw
Bekijk gratis de handleiding van Vestil CH-10-12, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Vestil |
| Model | CH-10-12 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 1488 MB |
