Vestil CBB-3000-37 handleiding
Handleiding
Je bekijkt pagina 15 van 19
TABLE OF CONTENTS Rev. 4/13/2023 CBB-3000-37 MANUAL
TABLE OF CONTENTS Copyright 2022 Vestil Manufacturing Co. Page 15 of 19
USING THE BALER
Do not attempt to compact anything but cardboard in the baler.
All cardboard containers must be empty. Do not attempt to compact filled boxes. Cardboard inside the
chamber should be level and evenly distributed within the chamber to prevent uneven loading of the baler
platen. Uneven loading could damage the platen, ram, or both.
1. Verify that the baler is connected to electrical power and ready
for operation. Check the stack light on top of the control box.
The stack light includes three colored lights: red, yellow, and
green. The green light should be illuminated. If none of the lights
are illuminated, then either baler is not connected to electrical
power or the E-stop button is pressed. Raise the E-stop button if
necessary.
2. If cardboard is already present in the baling chamber, proceed
to step 4. If the baling chamber is empty:
a. Press the red E-STOP button;
b. Turn the turnbuckle wheel in the OPEN DOOR direction to
release the door latch; and then
c. Open the baling chamber door and place a full sheet of
cardboard on the floor of the baler.
3. Close the baling chamber door. Latch the door by turning the
turnbuckle wheel in the CLOSE DOOR direction. Turning the
wheel brings the door latch into solid contact with the free end
of the chamber door. The green stack light illuminates when the
door is closed.
4. Turn the red E-STOP button clockwise until it pops up.
5. Raise the gate and evenly add cardboard to the baling
chamber until the chamber is full. DO NOT put material other
than cardboard in the baling chamber. The baler must only be
used to compact cardboard.
6. Grasp the gate latch handle & pull the gate all the way down.
7. Turn the mode selection switch to the desired mode of operation:
MANUAL or AUTO (automatic). In MANUAL mode, the ram only
moves while the operator presses control buttons. In AUTO
mode, the ram extends and returns to home position entirely on
its own after the operator presses and releases the CYCLE START
button. The baler should generally be operated in AUTO mode.
8. Compact the cardboard in the baling chamber.
a. If AUTO mode is selected, press the CYCLE START button.
Release the button when the platen begins to move and the
yellow stack light turns on. The ram extends and causes the
platen to compact the cardboard in the chamber. The ram
automatically reverses direction and returns to home
position. The green stack light turns on when the platen
reaches home position.
b. If MANUAL mode is selected, press and hold both the CYCLE START and DOWN buttons. The ram extends
and presses the platen against the cardboard in the chamber. The ram automatically stops moving when
the cardboard is fully compacted. Press both the CYCLE START and UP buttons to raise the platen. The
platen automatically stops moving when it reaches home position.
NOTE: ONLY perform step 7 in MANUAL mode to make less-than-full-sized bales.
9. Repeat steps 4-8 until the bale-full condition occurs.
a. In AUTO mode, the platen stops and does not return to home position and the red stack light turns on. The
red stack light illuminates when the baler is full.
b. In MANUAL mode, the platen stops moving on its own and the red stack light turns on.
10. If operating in AUTO mode, turn the mode selector switch to MANUAL.
11. Press and hold the CYCLE START and UP buttons until the platen is in home position. Open the gate. Place a
full sheet of cardboard on top of the bale. Close the gate. Press and hold both the CYCLE START and DOWN
buttons until the platen stops and the red stack light turns on. Then, press the red E-STOP button on the control
box.
Stack Light
E-STOP button:
Press in to
activate; turn
clockwise until
button pops out to
turn off.
Mode Selection
Switch
Bekijk gratis de handleiding van Vestil CBB-3000-37, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Vestil |
| Model | CBB-3000-37 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 5154 MB |
