Vestil APG-M-48 handleiding
Handleiding
Je bekijkt pagina 4 van 6
9/6/2022 APG, MANUAL
Copyright 2022 Vestil Manufacturing Corp. Page 4 of 6
.
Step 5: Install other posts and panels as required. As before, determine the desired height of the top of each panel. Mark
the post to show the top and bottom edges of the panel. Measure 5½ in. below the top edge mark and mark the post.
Step 3: Choose the desired vertical position of the gate with respect to the post. Mark the post with the location of each of
the 8 bolt holes in the hinge plate. [NOTE: Make sure that the hinge pin islets lie above the surface of the post, otherwise
the gate will not close properly. See “Cross-section” diagram below.]
Use a 3/16 in. bit to drill holes for the self-drilling screws.
To fasten the gate to the post, slide a flat washer onto each screw; then insert the screws into the holes and tighten them.
FIG. 3: Cross-Section (Top View) of Gate-Hinge Connection
Post
¼ in. x 1½ in. self-drilling screw
Flat washer
Hinge plate
Hinge pin islet
Gate
Post
Gate
Hinge
pin islet
Step 4: Install the other gate post. First attach the latch plate to the post. Hold the plate against the post so that one
side is flush with the outer edge of the post; adjust the location of the plate so that the latch bolt aligns with the
opening in the latch plate. Mark the locations of the bolt holes; then drill 3/16 in. holes and fasten the plate to the
post with 2 self-drilling screws.
After the latch plate is installed, determine the ideal location for the second post. The post should be close enough
to the other post (approximately 49-7/8 in. to 50 in., which is equal to ~126cm) to allow the latch bolt to seat securely
within the opening in the latch plate. Ideally, at least 1/2in. of the bolt should extend into the opening.
Perform steps 1 and 2 on p. 4 to prepare the surface for installation and to anchor the post to the ground.
The latch plate
should mount
flush with the
outside edge
of the post. If
improperly
attached, the
gate will not
latch correctly.
Match the
location of
the opening
in the latch
plate with
the latch
bolt.
Align
latch
bolt with
the
opening
in the
latch
plate.
Latch
knob
(inside
gate)
Latch key
(outside
gate)
Opening in
latch plate
Inside edge
Outside edge
FIG. 4: Hinge
Hinge
plate
Bekijk gratis de handleiding van Vestil APG-M-48, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Vestil |
| Model | APG-M-48 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 2710 MB |
