Vestil ALL-T-1-GPT-ST-L handleiding
Handleiding
Je bekijkt pagina 7 van 15
Table of Contents 2/13/2024 ALL-T-1-GPT-ST-L MANUAL
Table of Contents Copyright 2022 Vestil Manufacturing Co. Page 7 of 15
Inspect the following components:
1. Motor: Maintain the motor as instructed in the motor manufacturer’s manual provided with the unit.
2. Drive chain (one for each drive wheel): every other oil
change, inspect the chains. To access the chains,
remove the cover plates fastened to both ends of the
drive housing. Refer to the appropriate Sprocket Drive
Subassembly on page 13.
A. Check the tension of both chains. They should not
be taut but also should not be so loose that they
slap against the housing or jump on the sprockets.
Adjust the chains by applying pressure to the hex
head with a wrench while loosening the lock nut.
B. Check set screws on the front and rear sprockets,
drive shaft coupling, motor pulley, and pump
pulley. Confirm that the set screws are tight.
Tighten all loose screws. Apply thread locker to
keep connections tight.
C. The front wheel sprocket should line up with the
axle sprocket
D. Lubricate the drive chains with spray grease as
needed, e.g. if the drive train becomes noisy.
3. At least once per month, remove the drive belt
guard. Determine the condition of the drive belt
(Exploded View and Bill of Materials on pages 8- 9;
part number 50-042-008) and drive pulley (part
number 50-027-003). Unseat the belt from the drive
pulley to relieve belt tension. Then, examine the
pump assembly (part number 50-643-001) idler pulley
on top of the pump as well as the pump bearings
and shaft. Look for damage and significant wear.
Replace any component, particularly the belt, which
is significantly worn.
4. Check the hydraulic system.
a. Before each use:
i. Cycle the carriage all the way up and then all the way down. Movement should be smooth
in both directions, i.e. no binding, jumps, skips.
ii. Check the hydraulic hoses for signs of wear, kinks, cuts, etc. Replace damaged hoses.
b. At least once per month, examine the hydraulic oil. The oil reservoir is located next to the hydraulic
pump. First, fully lower the carriage. Remove the brass fill plug from the top of the reservoir and
examine the oil. Change the oil if it darkens, becomes gritty, or has a milky appearance (indicating
that water is present). Replace the oil with AW-32 hydraulic fluid or its equivalent.
c. Before each use,
5. Before each use make sure all labels are in place & in readable condition. See Labeling diagram, p. 14.
6. Periodically clean dirt and debris from all surfaces to keep the finish in good condition. Store the unit
indoors.
Drive belt
guard
Cover
plate
Cover
plate
DRIVE
HOUSING
Chain guard
Hex
head
Lock
nut
Bekijk gratis de handleiding van Vestil ALL-T-1-GPT-ST-L, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Vestil |
| Model | ALL-T-1-GPT-ST-L |
| Categorie | Vorkheftruck |
| Taal | Nederlands |
| Grootte | 4332 MB |
