Vestil ALL-T-1-GPT-ST-L handleiding
Handleiding
Je bekijkt pagina 5 van 15
Table of Contents 2/13/2024 ALL-T-1-GPT-ST-L MANUAL
Table of Contents Copyright 2022 Vestil Manufacturing Co. Page 5 of 15
a. Grasp the knob of the fork carriage control lever and push it UP/towards the truck. The
hydraulic cylinder extends and causes the carriage to rise.
b. Releasing the lever causes to cylinder to stop extending. The cylinder maintains position
wherever it stops. Release the control lever as soon as the desired load elevation is
achieved.
NOTE: Do not continue to hold the control lever when the cylinder is completely
extended. The hydraulic fluid could overheat and cause permanent damage to the
hydraulic system.
2. Lower the fork carriage: The engine does not have to be running to lower the carriage.
a. Pull the control lever DOWN.
b. The carriage descends at a controlled speed. Releasing the lever causes the carriage
to stop. It maintains position wherever it stops. Lowering speed is adjustable. However,
the lowering speed is optimized at the factory. Do not change the lowering speed
without approval from, and guidance by, Technical Service. Technical Service contact
information is provided on the cover page of this manual.
If the carriage lowers too quickly, a safety device in the cylinder, called a velocity
fuse, closes. When the fuse is closed, hydraulic fluid cannot flow from the cylinder to the
reservoir. The cylinder cannot retract and the carriage does not lower. If this happens,
you must reset the velocity fuse by raising the hitch.
Before engaging the load:
1. Release the direction control lever.
2. Adjust the engine throttle to mid-speed.
3. Align the forks (on the carriage) with the fork channels in the pallet. The forks must be
centered on the carriage.
4. Adjust the elevation of the forks with the Raise/Lower lever.
Mount the pallet on the forks:
1. Drive forward and insert the forks through the pallet. Insert the forks all-the-way. Fork length
should be at least
2
/
3
’s of the parallel dimension of the pallet.
2. Raise the forks to elevate the pallet a few inches above the ground. Do not raise the forks
any higher than necessary.
3. Drive the load to the desired location. Instructions for driving and steering the truck are
provided in Operating the Truck on p. 4.
4. Set the pallet on the ground by lowering the forks. When the pallet rests on the ground,
extract the forks from the pallet by driving the truck in reverse.
LIFTING AND TRANSPORTING LOADS
Bekijk gratis de handleiding van Vestil ALL-T-1-GPT-ST-L, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Vestil |
| Model | ALL-T-1-GPT-ST-L |
| Categorie | Vorkheftruck |
| Taal | Nederlands |
| Grootte | 4332 MB |
