Vestil A-LIFT-CB-EHP handleiding
Handleiding
Je bekijkt pagina 9 van 15
Table of Contents Rev. 1/29/2024 A-LIFT, MANUAL
Table of Contents Copyright 2023 Vestil Manufacturing Co. Page 9 of 15
USING THE A-LIFT
This product is a “manually-propelled high lift industrial truck” according to the national standard
ANSI/ITSDF B56.10 (“B56.10”). Acquire a copy of the most recent revision of B56.10, which is freely
downloadable at no cost from the ITSDF website (www.itsdf.org). Review the operation recommendations.
Instructions in this manual are meant to supplement the recommendations of B56.10.
ONLY use this device after completing the training program outlined in B56.10.
Develop safe working habits and an awareness of hazardous conditions occurring or present during
operation of the lifter. Do NOT use the lifter on stairs. Only use the lifter on even, level concrete/asphalt
surfaces.
Inspect the lifter as recommended in the INSPECTION & MAINTENANCE section of this manual on page 13.
Use the lifter only if it is in satisfactory condition.
Inspect the area where the lifter will be used before each use to identify unusual operating conditions.
Implement additional safety precautions as conditions require. Conditions might include:
1. Irregularities in the floor/surface;
2. Debris or other obstructions on the floor/surface;
3. Unsound surfaces, i.e. surfaces that cannot support your weight plus the weight of the lifter and a
full capacity load.
Perform the following function tests before each use:
1. Raise and lower the deck and confirm normal operating condition of the winch, pulleys, carriage
and all associated mechanisms.
2. Test the casters/wheels: wheels should roll smoothly, should not be severely worn, and should be
rigidly fastened to the frame of the lifter.
3. Confirm that the caster locks/brakes function normally. See Step 4 on p.10.
UStep 1 (-S and -CB Models)U: Adjust the legs to provide the desired wheel base. Set the brake (-S models) or
lock the casters (-CB models). Remove the forks and lock the carriage using the pivoting carriage latch
(photo a). Slowly tilt the lifter backwards until the loading wheels contact the ground. Pull the leg
adjustment peg (photo b) and slide the leg in the desired direction. Reset the peg in the first or second
adjustment setting (photo c) as the job requires.
UStep 2U : Grasp the handle with both hands. Walk behind the lifter and keep your feet away from the wheels.
a. Grasp the
operator
handle at
each end.
This will
provide the
greatest
degree of
steering
control.
b. Walk behind the lifter and
keep your feet clear of the
casters.
DO NOT place
one foot on the counterweights
and propel the lifter with the
other foot. Doing so will make
the lifter more difficult to control.
a
b
c
1
2
a
b
Bekijk gratis de handleiding van Vestil A-LIFT-CB-EHP, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Vestil |
| Model | A-LIFT-CB-EHP |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 10610 MB |
