Handleiding
Je bekijkt pagina 39 van 87
English - 38 -
Mode, Frequency, and Network
ID options may be available. The
options may vary depending on
the operator and the Scan Mode
selections. If you don’t know how to
set other options, set the Scan Mode
to Full (if available). Highlight Scan
and press OK or the Right directional
button to start the scan. You can
press OK or the Back/Return button
to cancel the scan. Then press OK
or the Back/Return button again
to exit. The channels that have
already been found will be stored in
the channel list.
Single RF Scan: Enter the Frequency
value. Signal Level and Signal
Quality of the selected frequency
will be shown. Highlight the Scan
option and press OK or the Right
directional button to start the scan.
The found channels will be stored in
the channel list.
Channel Scan Type: Set your scan
type preference.
Channel Store Type: Set your store
type preference.
Auto Channel Update: Turn the
auto channel update function on
or o.
Channel Update Message: Turn the
channel update message function
on or o.
Satellite
Channel Installation Mode: Set
this option as Preferred Satellite
or General Satellite. The channel
list will also change depending
on the selected option here. In
order to watch the channels on
the satellite you want, this option
should be selected accordingly. Set
to Preferred Satellite to watch
operator channels, if you have
performed an operator installation.
Set to General Satellite to watch
other satellite channels, if you have
performed a normal installation.
Satellite Re-scan: Start a satellite
scan beginning with the antenna
selection screen. When this scanning
option is preferred, some scanning
congurations will not be available
and thus the preferences you made
during the initial setup or factory
reset process may not be changed.
For the General Satellite channel
installation mode the SatcoDX
Scan option may also be available
here. For standard installation
select Normal scan. For SatcoDX
installation select SatcoDX Scan
and copy the relevant sdx file
into the root directory of an USB
storage device and connect it to
your TV. Highlight this option and
press OK or the Right directional
button. The Download SatcoDX
option will be highlighted, press OK
or the Right directional button to
continue. Select the sdx le from the
connected USB storage device and
press OK. Satellite selection screen
will be displayed. The status of the
Bekijk gratis de handleiding van Vestel 55UG9750, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Vestel |
| Model | 55UG9750 |
| Categorie | Televisie |
| Taal | Nederlands |
| Grootte | 8815 MB |
