Handleiding
Je bekijkt pagina 21 van 81
English - 20 -
OK or the Right directional button
to proceed.
Once you are done with setting
available options, press the Right
directional button to proceed. The
TV will start to search available
broadcasts.
While the search continues you can
press the Back/Return button to stop
the search. Then highlight Skip Scan
and press OK or the Right directional
button to complete the setup. The
channels that have already been found
will be stored in the channel list.
Satellite
If the Satellite option is selected,
the Antenna Type screen will be
displayed next. If you have a Direct
satellite system, you can proceed to
the next step quickly by selecting the
Next option here. Highlight More
and press OK to set the antenna type
manually. Single, Tone Burst, DiSEqC
and Unicable options are available.
Highlight the antenna type that
corresponds to your satellite system
and press OK or the Right directional
button to proceed to the next step.
Next screen may be the Select
Operator screen. You can select only
one operator from the list. Highlight
the desired operator and press OK
or the Right directional button to
proceed. Some of the options in the
following steps may be preset and/
or additional steps may be added or
some steps may be skipped depending
on the selected operator in this step.
Check the parameters in each step
before proceeding and adjust if
necessary. You can highlight General
and press OK or Right directional
button to proceed with normal satellite
installation.
LNB List screen will be displayed next.
You may be able to set up dierent
satellites depending on the selected
country, antenna type and operator
in the previous steps. Highlight the
desired satellite option and press OK
or the Right directional button to set
the parameters. The Satellite Status
of the rst satellite option will be set
as On. In order to enable channel scan
on the satellite, this option should be
set as On rst.
Following satellite parameters will
be available. You may not be able to
change all settings depending on the
previous selections.
Satellite Status: Set the status
option to On to enable channel
search on the selected satellite.
Highlight this option and press OK
to change the status.
Satellite Selection: Select the
satellite on which you want to perform
a channel search.
Scan Mode: Set your scan mode
preference. Network and Full
options will be available. If you are
going to perform a network scan,
make sure that you have adjusted the
Frequency, Symbol Rate (Ksym/s)
Bekijk gratis de handleiding van Vestel 55QG9950, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Vestel |
| Model | 55QG9950 |
| Categorie | Televisie |
| Taal | Nederlands |
| Grootte | 8518 MB |
