VARI-LITE VL800 EventProfile handleiding
Handleiding
Je bekijkt pagina 25 van 38
UsEr manUaL
www.Vari-LitE.com
VL800 EVEntprofiLE
25
A DMX termination connector is used in this process. Solder a 120 Ω 1/4W resistor between pin 2 (DMX-) and
pin 3 (DMX+) into a 5-pin XLR-plug and plug it in the DMX-output of the last unit. A maximum of 32 luminaires
can be connected to one DMX512 data link.
Connect the unit together in a “daisy chain” by XLR plug from the output of the unit to the input of the next
unit. The cable can not branched or split to a “Y” cable. DMX 512 is a very high-speed signal. Inadequate or
damaged cables, soldered joints or corroded connectors can easily distort the signal and shut down the system.
The DMX output and input connectors are pass-through to maintain the DMX circuit, when one of the units’
power is disconnected.
Each lighting unit needs to have an address set to receive the data sent by the controller. The address number is
between 0-511 (usually 0 & 1 are equal to 1).
The end of the DMX 512 system should be terminated to reduce signal errors.
5 pin XLR: Pin 1: GND, Pin 2: Negative signal (-), Pin 3: Positive signal (+), Pin 4/Pin 5: Not used.
4
OPeraTIOn
Bekijk gratis de handleiding van VARI-LITE VL800 EventProfile, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | VARI-LITE |
| Model | VL800 EventProfile |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 4083 MB |
