Valberg WD 10714 A 10/D W180C Handleiding (144 Pagina's)

Handleiding

30

EN

Troubleshooting guide

Depending on the model, your washing machine is equipped with various automatic safety

functions. This enables faults to be detected in good time and the safety system can then

react appropriately. These faults are frequently so minor that they can be resolved within a

few minutes.

Problem Check whether / Possible cause

The washing machine will

not start, no indicator lamps

are on.

• the mains plug is inserted into the socket

• the wall socket is functioning correctly (use a table

lamp or similar appliance to test it).

The washing machine will

not start... and the “Start/

Pause” indicator lamp

flashes.

• the door is properly closed (child safety);

• the “Start/Pause” button has been pressed;

• the “Water tap closed” indication lights up. Open the

water tap and press the “Start/Pause” button.

The appliance stops during

the programme (varies

depending on model).

• the door has been opened and the “Start/Pause”

indicator lamp is ﬂashing. Close the door and press

the “Start/Pause” button again.

• Check if there is too much foam inside, machine

enters kill-foam routine. The machine will run again

automatically after a period.

• the washing machine’s safety system has been

activated (see “Fault description table”).

Residue from detergent

and additives left in the

detergent drawer at end of

wash.

• the cover grid of the softener chamber and the

separator of the main wash chamber are correctly

installed in the detergent dispenser and all parts are

clean (see “Care and maintenance”);

• sufﬁcient water is entering. The mesh ﬁlters of

the water supply could be blocked (see “Care and

maintenance”);

• the position of the separator in the main wash

chamber is adapted to the use of powder or liquid

detergent (see “Detergent and additives”).

Machine vibrates during spin

cycle.

• the washing machine is level and standing ﬁrmly on

all four feet;

• the transport bolts have been removed. Before using

the machine, it is imperative that the transport bolts

are removed.

Cleaning and maintenance

C

Bekijk gratis de handleiding van Valberg WD 10714 A 10/D W180C, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.