Valberg ST3 handleiding
Handleiding
Je bekijkt pagina 8 van 50
7
EN
Operation
WARNING - RISK OF BURNS!
•
The mop head (11) releases steam when in operation and its surroundings
become hot during use. It will remain hot for some time after use. Do not
touch the hot surfaces or get near its surroundings. Always use the handle.
•
The steam mop generates high temperatures of steam. Never direct the
steam or mop head towards people or pets.
• This product is intended for FLOOR cleaning only. Do not use it in horizontal
position.
NOTE:
•
Slight odors might present at the beginning of usage until the product reaches
its thermal stability.
•
You may notice water residue in/on the product. This is normal as it is the
result of quality testing for product performance and safety.
1.
Pull the cover of the water inlet (12) to open. Slowly fill the water container (13) with distilled
water at room temperature using the measuring cup (B). Make sure water level does not
exceed the MAX line marked on the main body (9). Close the cover of the water inlet .
NOTE: Do not add any other substances to the clean water (for example, perfume,
vinegar, starch, cleaning gel or other chemicals), or pour in hot water to the water
container as these can result in product malfunction.
2.
Adjust the length of the telescopic tube (3) by releasing the clip lock on the tube and extend
the tube to your desirable length. Then, fasten the clip lock to secure it .
3.
Spread out the power cable (14) to avoid entangling and plug it into the mains supply.
When powered on, the product emits a beep sound.
4. Rotate the steam intensity knob (7) clockwise to select a steam mode and the indicator
light (6) light up accordingly (Low : green / Medium : blue / High : red). There will be one
beep sound along with each rotation of knob .
5. After selecting the steam mode, heating will start immediately and be completed within
20 to 40 seconds. The product will then start releasing steam and the Indicator light (6)
will stay on.
6.
When the steam becomes consistent, the product is ready to use. To start cleaning the
floor, hold the handle tightly and tilt the steam mop at an angle of approximately 45
degrees to move it back and forth .
7.
If you need to pause, stop or finish cleaning, put the product in vertical position, rotate
the steam intensity knob (7) counter-clockwise to the position .
8.
Unplug the product from the mains supply and let it cool down before cleaning it or
storing it away.
Product usage
B
Bekijk gratis de handleiding van Valberg ST3, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Valberg |
| Model | ST3 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 3646 MB |
