V-Tac VT-12151 handleiding

46 pagina's
PDF beschikbaar

Handleiding

Je bekijkt pagina 37 van 46
___________________________________________
36
5. Installation and Configuration
5.1 Preparation for installation
5.1.1 Safety Requirement
This system can only be installed by personnel who have been trained in the power supply
system and have sufficient knowledge of the power system.
The safety regulations and local safety regulations listed below should always be followed during
the installation.
All circuits connected to this power system with an external voltage of less than 500V
must meet the SEHV requirements defined in the IEC60950 standard.
If operating within the power system cabinet, make sure the power system is not
charged. Battery devices should also be switched off.
Distribution cable wiring should be reasonable and has the protective measures to avoid
touching these cables while operating power equipment.
when installing the battery system, must wear the protective items below:
The isolation gloves
Safety goggles
Safety shoes
5.1.2 Environmental requirements
Charging temperature range is 0
~+45
,
Discharging temperature range is -10
~+55
Storage temperature: 0
~ +35
Relative humidity: 5% ~ 85%RH
Elevation: no more than 2000m
Operating environment: Indoor installation, sites avoid the sun and no wind, no conductive dust and
corrosive gas.
And the following conditions are met:
Installation location should be away from the sea to avoid brine and high humidity environment.
The ground for product arrangement shall be flat and level.
N
o flammable explosive materials near the installation site.
The optimal ambient temperature is 15
~ 30
Keep away from dust and messy zones

Bekijk gratis de handleiding van V-Tac VT-12151, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.

Productinformatie

MerkV-Tac
ModelVT-12151
CategorieNiet gecategoriseerd
TaalNederlands
Grootte15636 MB