V-Tac VT-120137S handleiding
Handleiding
Je bekijkt pagina 3 van 5
MULTIPLE (LINKABLE) UNITS INSTALLATION INSTRUCTIONS
Note: Please refer to the model number and max linkable units which can be linked together. Based on the max linkable units select the max
waterproof fittings which you would like to connect.
WATERPROOF CONNECTOR
WATERPROOF
END WIRE
STEP 5: Wiring 1st waterproof fitting from both
the ends - Fasten the waterproof connector
clockwise from the first end and insert the
cable through the waterproof connector and
wire into the terminal block from one end
[L(Live) & N(Neutral)] and wire the sensor into
other side or terminal block. Wiring must done
according to the schematic diagram.
STEP 6: Fasten the waterproof
connector from other end of the
waterproof fitting and insert the
wire into the terminal block.
Using the same cable fasten the
waterproof connector of the 2nd
waterproof fitting and wire into
the terminal block.
STEP 8: Wire the waterproof fitting to
the main power supply.
Ensure to use waterproof terminal
block [not included].
STEP 9: Switch ON the power to test
the light.
STEP 7: Install the diuser to the waterproof fitting and
close the clips.
STEP 2: Fix the mounting
brackets onto the ceiling
using screws and expansion
plug(included). Please refer
to table for installing the
mounting bracket distance
points.
STEP 3: Mount
water proof lamp
onto the mounting
brackets.
STEP 4: Open the side
clips of waterproof
fitting and open the
diuser as shown in
the diagram.
STEP 1: Switch
OFF the power
before starting
the installation.
Bekijk gratis de handleiding van V-Tac VT-120137S, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | V-Tac |
| Model | VT-120137S |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 878 MB |
