UniView IPC2228SE-DF40K-WL-I0 Handleiding (135 Pagina's)

Handleiding

129

CAUTION!

Restarti

ng the camera will interrupt the ongoing service.

Click Restart and then confirm to restart the device. You may set a schedule to reboot the camera

automatically at the set time.

 Heater

Use the heater to eliminate water droplets on the lens in a high humidity environment.

(1) Enable Heater.

(2) Set Remaining Heating Time.

2. Network Diagnosis

Go to Setup > System > Maintenance > Network Diagnosis.

 Select NIC

NIC1 is the camera’s IP address.

 IP/port filter

 All: Capture all packets of the camera.

 Specify: Capture packets of the specified port or IP.

 Filter: Filter packets of the specified port or IP and capture other packets.

 Custom Rules

Select Custom Rules and set the rules.

Click Start Capture to start capturing packets. After packet capture is finished, save data and view the

diagnosis.

 Test network delay and packet loss rate

Test network connectivity by sending test packets to a test address.

 Test Address: Must be a valid IP address or domain name.

 Packet Size (Bytes): Size of test packets to be sent. Range: [64-65507]. Sometimes a high delay

may be caused by a large packet size. If the test failed, set a smaller packet size and then try

again.

Bekijk gratis de handleiding van UniView IPC2228SE-DF40K-WL-I0, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.