Tunturi FitRow 90i handleiding

Niet gecategoriseerd

Tunturi

64 pagina's

PDF beschikbaar

Handleiding

Maintenance

Item

Time Frame Instructions

Seat Rails and Wheels Weekly Wipe down Side Rails and Seat Wheels with lint free cloth.

Frame Weekly Wipe down Frame with lint free cloth.

Tank Shell Weekly

Only use water and a clean cloth to wipe the Tank Shell.

Do NOT use any chemical cleaner to wipe the Tank Shell

Tank and Water

Treatment

12 months to 2 years

Follow instructions as specified in the “Water Treatment Procedure”

section of this manual.

Bungee Cord

Check every hundred

hours for correct tension

and for signs of wear.

The Bungee Cord should last for many years. If a Bungee Cord change

is required, please contact your local service representative or go

online at www.fluid-eu.com for further details.

Rowing Belt

Check every hundred

hours for correct tension

and for signs of wear.

The Rowing Belt should provide many years of trouble free use.

If a Rowing Belt change is required, please contact your local service

representative or go online at

www.uid-eu.com

for further details.

All preventive maintenance activities must be performed on a regular basis. Performing routine preventive maintenance

actions can aid in providing safe, trouble-free operation of all Tunturi New Fitness BV equipment.

Tunturi New Fitness BV is not responsible for performing regular inspection and maintenance actions for your machines.

Instruct all personnel in equipment inspection and maintenance actions and also in accident reporting and recording.

Wipe and clean the Tank, Rails, and the Seat Wheels with clean water.

Do not use any chemical cleaner.

CAUTION

Troubleshooting

..........................................................................................................................................................

Fehler Mögliche Ursache Lösung

Water changes color or

becomes cloudy.

Strength Machine is in direct

sunlight or has not had water

treatment.

Change Strength Machine location to reduce direct

exposure to sunlight. Add Water Treatment Tablet or change

Tank water as directed in the Water Treatment section of this

manual. Consider using distilled water to refill Tank.

Belt slipping off Belt/

Bungee Pulley.

Bungee not under enough

tension.

Tighten Bungee Cord following the instructions in "Replacing

the Bungee/Shock Cord" section of this manual.

Front of the Strength

Machine lifts slightly

during vigorous rowing.

M10X150mm Vertical

Seat Rail Tensioning Bolt is

slightly too loose.

Tighten Bolt 1/2 turn and row again. Tighten as needed until

problem stops. Note: Over tightening this Bolt can damage

the seat rail. Only tighten Bolt in small increments until fault is

corrected.

Inconsistent readings on

the Monitor for 500meter

split time and SPM

(strokes per minute).

Sensor gap

Faulty Sensor

Sensor has moved out of

position

Wiring harness

Use the battery cover of the Monitor as a “Gap Tool” to check

the gap between Sensor Head and Magnetic Ring, or see if the

Sensor Head has moved out of position.

Please contact your nearest FLUID customer service center for

details.

The Monitor does not

illuminate after battery

installation.

Batteries installed incorrectly

or need replacing.

Replace/reinstall batteries in correct position and try again.

If the LCD screen fails to illuminate, try rotating the batteries

slightly in the Monitor.

If this fails, contact your local service center.

The Monitor screen

illuminates, but does not

Loose or failed connection.

Sensor gap too wide

Check that the Monitor lead is connected properly. If it is

connected then contact your local service center. Check Sensor

gap.

Bekijk gratis de handleiding van Tunturi FitRow 90i, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.