Tryton TSO15251 handleiding
Handleiding
Je bekijkt pagina 8 van 48
8
containing materials can be machined by specially trained personnel
only.
– Always keep the workplace well ventilated.
– Dust masks are recommended.
Observe all valid national and local regulations on handing materials to
be machined.
n Wet grinding
To provide optimum efficiency of the low speed fine grinding wheel (8),
intended for wet grinding, fill up the special container (9) with water.
NOTE: Do not allow water to drip onto the motor during filling.
It is recommended to turn the grinder off and fill the container (9) with
water to immerse the grinding wheel to the depth of 1-2 cm. Then turn
the grinder on and start grinding, remembering not to apply excessive
pressure, as wet grinding requires less pressure than dry grinding.
After completing all necessary operations empty the container by
removing its plug (10).
MAINTENANCE AND STORAGE:
This power tool does not require any special maintenance. Store the
machine in a place away from children, keep it clean and protect from
humidity and dust. Storage conditions should exclude any mechanical
damage and weathering.
This device meets the requirements of both national and European
standards and safety guidelines. Any repair should be carried out only by
qualified personnel using original spare parts.
n Cleaning
NOTE: Before carrying out any cleaning unplug the machine from the
mains.
To provide safe and efficient operation it is recommended to clean the
tool directly after each use.
Remove any deposits using compressed air.
Clean the grinder housing with clean damp cloth and some soap. Do not
use any cleaning agents and solvents, as they can damage machine
plastic components. Protect machine interior against water penetration.
PROTECTION OF THE ENVIRONMENT:
NOTE: The symbol nearby denotes that old equipment must
never be thrown away together with other waste (with the
penalty of a fine). Hazardous components of electronic
equipment may adversely affect the natural environment
and human health.
Each household may contribute to the recovery and reuse (recycling) of
old machinery and equipment. Both in Poland and Europe a system for
recovery of used equipment either exists or is being created. The system
obliges all organizations that sell such equipment to collect the used
machinery and appliances. Moreover, general purpose collecting points
for such equipment are available.
MANUFACTURER:
PROFIX Ltd.,
34 Marywilska Street, 03-228 Warsaw, POLAND.
PICTOGRAMS:
Explanation of the icons located on the nominal plate and the
information tags:
«Always wear safety goggles»
«Wear hearing protection»
«Wear a dust mask»
«Read this instruction before switching on the
power supply and starting the work»
The policy of the PROFIX company consists in permanent improvements of the offered products and therefore the company
reserves the right to make amendments to the product specification without a prior notice. The images included into the
operation manual are only of the exemplary nature and may slightly differ from actual appearance of the device
purchased.
This instruction manual is protected by copyright. Copying it without the written consent of PROFIX Co. Ltd. is prohibited.
Bekijk gratis de handleiding van Tryton TSO15251, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Tryton |
| Model | TSO15251 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 9060 MB |
