Tripp Lite B013-330-USB handleiding
Handleiding
Je bekijkt pagina 7 van 20
7
5. Installation
Before you install the TX/RX units of the CAT5 USB KVM Extender
B13-330-USB, ensure the following is ready:
1. The computer for extension should be one with USB interfaces.
2. Check the display mode of the computer to be within 1920 x 1200
resolution and that the refresh rate is set at 30 or 60 Hz.
3. Prepare two sets of keyboards, mice and monitors: one set for
local-site transmitter console and the other set for remote-site
receiver console.
4. The two monitors used (one at the TX site and the others at the RX
site) should be of the same resolution, and ideally the same
model.
5. Since the CAT5 USB KVM extender only supports standard 5-key
mouse and keyboard, any advanced mouse/keyboard function will
not be supported by the CAT5 extender.
6. Use good quality CAT.X UTP cable, maximum 328 ft. (100 m).
Note: a high-quality cable will ensure better video quality even over longer
distances. Signal degradation increases as the cabling distance increases.
7. The choice of path of the CAT.X UTP cable should not only
consider the shortest path, but also consider any significant
sources of electromagnetic interference.
8. There should be power outlets near where you locate the
extenders. Take the package items out of the box and begin
installation.
Take the package items out of the box and begin installation.
Bekijk gratis de handleiding van Tripp Lite B013-330-USB, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Tripp Lite |
| Model | B013-330-USB |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 2025 MB |
