Handleiding
Je bekijkt pagina 7 van 20
6A - SERVICE INFORMATION (cont’d):
If service is not satisfactory, please contact our in-house service
department at: Traulsen
4401 Blue Mound Road Fort Worth, TX 76106
(800) 825-8220
Traulsen reserves the right to change specications or discontinue
models without notice.
6B - SPARE PARTS:
Spare or replacement parts may be obtained through a parts
supplier or one of our authorized service agents (see page 17-18
for parts listing). A list of authorized service agents is posted on
our company’s ofcial website Service tab at www.traulsen.com.
6C - WARRANTY REGISTRATION:
The warranty for your new Traulsen unit may be registered with
us by completing warranty information online, via our website
www.traulsen.com click on Service Tab or calling us direct at
800-825-8220.
5D - CLEANING THE EXTERIOR:
Exterior stainless steel and aluminum should be cleaned
with warm water, mild soap and a soft cloth. Apply with
a dampened cloth and wipe in the direction of the metal
grain.
Avoid the use of strong detergents and gritty, abrasive
cleaners as they may tend to mar and scratch the surface.
Do NOT use cleansers containing chlorine, this may
promote corrosion of the stainless steel.
Care should also be taken to avoid splashing the unit with
water, containing chlorinated cleansers, when mopping
the oor around the unit.
For stubborn odor spills, use baking soda and water
(mixed to a 1 TBSP baking soda to 1 pint water ratio).
5E - CLEANING THE INTERIOR:
For cleaning anodized aluminum interiors, the use of bak-
ing soda as described in section “V. d” is recommended.
Use on breaker strips as well as door gaskets. All interior
ttings are removable without tools to facilitate cleaning.
5F - ADJUSTING THE SHELVES:
For shelves mounted on pins, rst select the desired
location and remove the white plastic covers in the inte-
rior back and sides by rotating them counterclockwise.
Remove the shelf pins by rotating them counterclockwise.
Install the pins in the desired location by rotating clock-
wise. Make sure the pin is securely tightened down. Do
not over tighten. Slide the shelf into its new position, and
replace the white plastic covers into the holes vacated
by the shelf pins.
6. OTHER
6A - SERVICE INFORMATION:
Before calling for service, please check the following:
Is the electrical cord plugged in?
Is the fuse OK or circuit breaker on?
Is the power switch “ON”?
If after checking the above items and the unit is still
not operating properly, please contact an authorized
Traulsen service agent. You may obtain the name of a
service agent from the Service tab of our website: www.
traulsen.com.
5. CARE & MAINTENANCE (cont’d)
Your new Traulsen G-Series Refrigerator, Freezer or Hot Food
is equipped with an electronic microprocessor control, which
precisely regulates operation. It is supplied from the factory com-
pletely ready for use. See pages 6 thru 14 for more information.
6. OTHER (cont’d)
7. MICROPROCESSOR CONTROL
7A - CONTROL FEATURES:
Internal Time Clock
• Eliminates defrost time clock (refrigerator and freezer models
only).
• See “Setting The 24-Hour Clock” on Page 11. (Also required at
“Start Up”)
Parameter/Service Levels
• See “Customer/Service Parameters” on Page 8 - 9.
Defrost - See “Setting Defrost” on page 12
• Customers can set up to 6 different defrost schedules. The defrost
schedule allows the customer to decide when defrosts will take,
preventing a defrost cycle during peak kitchen use. NOTE: The
24-hour clock must be set for this feature to operate correctly.
G SERIES
Page 6
Bekijk gratis de handleiding van Traulsen G10010, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Traulsen |
| Model | G10010 |
| Categorie | Koelkast |
| Taal | Nederlands |
| Grootte | 3471 MB |
