Handleiding
Je bekijkt pagina 4 van 18
-3-
III. c - INSTALLING LEGS OR CASTERS (cont’d)
Please note that Centerline units are not designed to be
moved while on legs. If the unit requires moving, a pallet
jack or fork- lift should be used to prevent damage.
III. d - INSTALLING DRAIN PAN
Centerline uprights are shipped with the drain pan wrapped
up and stored inside the unit.
Remove the full-size sheet pan (drain pan) and slide it on
the rails underneath the cabinet. Route the drain tubing
through a bracket on the side wall to form a loop before
dropping it into the drain pan. This will allow the water to
drain into the pan.
III. e - SHELVES
The unit is supplied with shelves and shelf clips to be
installed on the pilasters. Check all shelf clips to assure
they are rmly in place as they may have come loose during
shipping. See section V.f for adjusting the shelves.
III. f - REMOVING DOORS & HARDWARE
In order to t through narrow (less than 33.5”) doorways, it
may be necessary to remove the door(s), access panels
and/or hinges. A Philip screwdriver may be required. First,
unlock and open door to its open feature position about 110°
and remove the screw holding each access panel (see gure
4 and gure 5).
After removing the screws, the panels can be pulled off the
pins to access hinge hardware. Set the top panel on top of
the unit as it will have wiring still attached to the control
display. The bottom panel of full door conguration can be
set aside. Half door conguration bottom panel may have
wiring attached to the door switch. If needed, the wiring
connectors can be disconnected so louver can be set aside.
After removing the panels, the hinge hardware can be
accessed.
NOTE: ALWAYS SUPPORT THE DOOR WEIGHT OPPOSITE
THE HINGE SIDE WHEN REMOVING TO PREVENT INJURY
OR DAMAGE TO THE DOOR.
Fig. 2
Tighten
Clockwise
Fig. 3
Drain pan sits on
rails under the unit
Drain Tubing
Routed Drain Tubing
Remove
Screws
Fig. 4
Pull panel corners off evenly;
avoid pulling one corner at a
time for easier removal.
NOTE: Top/bottom louvers
contain door switch for
controlling interior lighting.
Special care should be taken
to prevent damaging the wiring
during removal.
Fig. 5
III. INSTALLATION (continued)
Remove the top & bottom hinge brackets from the unit. Remember
to support the door weight opposite the hinge side.
The bottom hinge plate
bolts can be removed.
Fig. 6
Bekijk gratis de handleiding van Traulsen CLBM-23F, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Traulsen |
| Model | CLBM-23F |
| Categorie | Vriezer |
| Taal | Nederlands |
| Grootte | 3673 MB |
