Tracer OK-V1 handleiding
Handleiding
Je bekijkt pagina 10 van 40
5. Slide the lter into the dust container so that the ange rests on the guides inside the conta-
iner (III). At the edge of the ange, there is a gap, into which one of the guides (IV) should be
inserted. A correctly installed lter is supported by a ange against all guides and one of the
guides has been inserted into the ange gap.
6. Mount the container with the lter to the vacuum cleaner housing. The lower edge of the
container should rest on the vacuum cleaner housing (V), then press, hold down the locking
button and snap the container into place on the housing.
Caution! If excessive force is required to latch the container, check that the lter is instal-
led correctly. Forceful latching of the container may damage the vacuum cleaner and cause
incorrect operation. The container installed correctly is ush with the housing at its entire
edge, the housing tongue ts in the lower opening near the edge of the container and the
locking button ts in the upper opening of the container (VI). A correctly installed container
cannot be removed otherwise than by pushing back the lock button.
Installation of accessories (VII)
1. Slide one of the attachments or a exible hose into the opening at the front of the dust
container. It is permissible to vacuum soft surfaces, e.g. carpets, upholstery, etc. without an
installed attachment or hose.
2. The exible hose joint without the embossed part is designed to be inserted into the opening of
the dust container and the joint with the embossed part should be inserted over the tip.
3. The brush attachment is used to clean surfaces that can be easily scratched. The narrow tip
attachment is used to clean hard-to-reach areas.
Preparing for operation
Check the vacuum cleaner tank, empty it of waste, if necessary. Check the lter. If the lter is
dirty, dry clean with a compressed air stream of no more than 0.3 MPa or wet under a stream of
running, warm water. Do not clean the lter in dishwashers or with a high-pressure water jet. If
dirt cannot be removed from the lter, replace it with a new one. Check the condition of the lter
seals, replace the lter with a new one if they show damage.
CAUTION! It is forbidden to work with a vacuum cleaner without a properly installed air
lter. This can cause damage to the vacuum cleaner as well as electric shock.
Working with a vacuum cleaner
CAUTION! It is forbidden to use a vacuum cleaner to vacuum hot ashes. The temperature
of waste suctioned by the vacuum cleaner must not exceed 40°C.
1. Make sure that all preparatory work has been carried out correctly. Make sure that the vacu-
um cleaner switch is in the “OFF” position. Insert the plug of the power cord into the mains
socket and the LED will light up on the plug. Then move the switch to the “ON” position (VIII).
After nishing work, turn off the vacuum cleaner using the on/off switch, and then unplug the
power cord from the mains socket. Start the maintenance of the vacuum cleaner.
Instruction manual
10
EN
Tracer OK-V1
Bekijk gratis de handleiding van Tracer OK-V1, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Tracer |
| Model | OK-V1 |
| Categorie | Stofzuiger |
| Taal | Nederlands |
| Grootte | 3581 MB |
