Tornado Vortex 13 TS050-W13-U handleiding

Boenmachine

Tornado

42 pagina's

PDF beschikbaar

Handleiding

18 19

OPERATION

1. Fill the freshwater tank with

cleaning solution at a maximum

temperature of 104°F (40°C).

Add cleaning solution per

manufacturer’s recommendations.

2. Press the red foot pedal lightly

with your foot and pull handle back

to start the motor. The brushes

and the drum will begin to rotate.

Pulling the handle towards you

WITHOUT pressing the pedal

lowers the machine and engages

the rotating brushes with the floor.

To stop working, return the handle

to the upright and locked position.

Prior to machine operation, pre-sweep floor to

remove debris before using the unit.

OPERATION

3. Move forward while sparingly

pushing the solution control button.

This button should only be pushed

intermittently based on the floor

type and amount of soil on the floor.

For tiled or stone floors apply very

little solution. Release the solution

control button to stop the solution

discharge approximately 12 inches

before end of forward motion.

Continue to move forward up to the

wall without pressing button.

4. Pull the machine backwards in the

same track WITHOUT discharging

any solution. When you reach the

starting point, change the track and

repeat the steps above. When you

are changing the track, allow some

overlap with the cleaned area to

ensure complete coverage. In case

of large halls, make a U-turn while

moving forward. If quick drying is

required, move on the same track

without discharging solution.

Should the machine fail to operate, please refer to the

troubleshooting section in the back of this instruction manual.

If the problem/remedy is not listed, please contact the

Tornado Technical Service Department

Bekijk gratis de handleiding van Tornado Vortex 13 TS050-W13-U, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.