Toa TT-104B handleiding
Handleiding
Je bekijkt pagina 9 van 16
9
Step 2. Program registration
Register the programs according to the contents written in the program table.
2-1. Set the Program switch to PROGRAM.
The Channel indicators (A, B, C, and D) and Pause mode indicator flash.
2-2. Press the A channel key to select the A channel.
The A channel indicator comes on, while both the Day mode and Time mode indicators flash.
2-3. Press the DAY mode key to put the timer in the day mode.
The Day mode indicator comes on. At the same time, the Day indicators from Monday to Sunday
flash.
2-4. Press the Day setting key (from Monday to Friday) to designate a day of the week.
Note
When the wrong Day setting key has been pressed, press the same setting key again, and the
corresponding Day indicator goes out. Then press the correct setting key.
2-5. Press the STORE key to register the day of the week.
The clock display indicates “PASS.” At this point, all days from Monday to Friday have been
registered into the A channel.
Note
The contents of the programs are not stored without pressing the STORE key.
2-6. Press the TIME mode key to put the timer in the time mode.
The Time mode indicator comes on. At the same time, a dotted line “– – – –“ flashes in the clock
display.
2-7. Set a clock for 08:55.
Press the HOUR key (one hour’s digit) 8 times.
The clock display shows “0800.”
Press the MIN key (ten minute’s digit) 5 times.
The clock display shows “0850.”
Press the MIN key (one minute’s digit) 5 times.
The clock display shows “0855.”
2-8. Press the STORE key to register the time 08:55.
The word “PASS” appears in the clock display, indicating the time 08:55 has been registered into the
A output channel.
Note
The content of the program is not stored without pressing the STORE key.
2-9. Repeat Steps 2-7 and 2-8 to register all the times from 09:00 to 17:30.
Notes
• Pressing the STORE key to register the unreal time other than one from 00:00 to 23:59 causes
characters “Err” to appear in the clock display and the attempt of its registration is refused. Correct
the time and register it again.
• When the same time is registered double, characters “Err” are indicated in the clock display.
• If a registration attempt is made in excess of the program capacity (30), the word “End” appears in
the clock display, refusing the registration.
2-10. Repeat Steps 2-2 through 2-9 to register days of the week and times into both B and C channels.
One minute's digit
Ten minute's digit
One hour's digit
Ten hour's digit
MINHOUR
Bekijk gratis de handleiding van Toa TT-104B, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Toa |
| Model | TT-104B |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 1355 MB |
