Toa TS-D1100-MU handleiding
Handleiding
Je bekijkt pagina 11 van 52
11
5.2. TS-D1000-SU Sub Control Unit
[Front] [Rear]
1. Power indicator (White)
Lights when power is supplied.
This indicator interlocks with the Master control
unit’s power switch operation when the Master
control unit and the supplied AC adapter are
connected to the Sub control unit.
2. Signal ground terminal
When connection of an external device to the TS-
D1000-SU results in the generation of audible
noise, connect this terminal to the Signal ground
terminal of the external device. Noise output should
be greatly reduced.
Note
This is not a protective ground connection.
3. Cable clamp
Route the power cable through this clamp to
prevent the AC adapter plug from accidentally
being disconnected.
4. DC inlet
Insert the power plug from the unit’s supplied AC
adapter into this inlet.
5. Conference unit connection terminals
RJ45 × 3
Connect conference units to these terminals using
CAT5e STP LAN cables. Up to 16 Conference units
can be daisy chain connected to each terminal.
However, there may be some restrictions on
the combinations of conference units that can
be connected to a single line. (See "SYSTEM
EXAMPLES" on p. 26.)
6. Sub-control unit connection terminals
RJ45 × 2
Connect the Master control unit or other Sub
control units to these terminals using CAT5e STP
LAN cables.
Tip
Either terminal may be used for connection.
5.3. TS-D1000-EX Extension Unit
[Top]
[Rear]
1
22
3
4
1. Power indicator (Green)
Lights when power is supplied.
This indicator interlocks with the Master control
unit’s power switch operation when the Master
control or the Sub control unit, and the supplied AC
adapter are connected to the Extension unit.
2. Mounting holes
Mounting holes for 3 mm (0.12") diameter screws.
Use these holes when attaching the unit to a wall
or other surface.
Note
Please note that the mounting screws themselves
are not supplied with the unit.
3. Conference unit connection terminals
RJ45 × 2
When extending the distance between two
Conference units, connect to either of these
terminals using a CAT5e STP LAN cable.
Tip
Either terminal may be used for connection.
4. DC inlet
Insert the power plug from the unit’s supplied AC
adapter into this inlet.
1
3
4
5 6
2
Bekijk gratis de handleiding van Toa TS-D1100-MU, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Toa |
| Model | TS-D1100-MU |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 5846 MB |
