Handleiding
Je bekijkt pagina 21 van 96
Water system en-us
21
5. Discard the ice cubes produced during the first
24hours, and dispense water for 5minutes and
discard.
14.2 Water dispenser
Dispense cold water via the water dispenser.
Putting the water dispenser into operation
Note:Once the appliance has been connected or a new
water filter has been installed, there will be air in the water
system.
Requirement:The appliance is connected to the drinking
water connection.
1. Keep dispensing water until it contains no more air
bubbles.
Remove any splashes of water with a dry cloth.
2. For hygiene reasons, dispense water for 5minutes and
discard.
Dispensing water
▶
Press and hold the glass against the dispensing button
or hold the glass under the water dispenser and
press .
Notes
¡ After a while of continuous dispensing, the water
stops being dispensed. Wait a few seconds before
dispensing water again.
¡ After water has been dispensed several times
consecutively, water stops being dispensed. Wait a
few minutes before dispensing water again.
14.3 Ice maker
Use the ice maker to produce ice cubes.
WARNING
Rotating parts may cause injury.
▶ Never reach into or underneath the ice maker.
Note:The ice cube maker automatically detects that the
ice storage container is full and stops producing ice cubes.
It may take up to 48hours until the ice storage container is
full.
Tips
¡ You can accelerate ice cube production by setting a
colder freezer compartment temperature or by switching
on Super freezing. This slightly increases the energy
consumption.
¡ If the ice cubes taste stale, dispose of the remaining ice
cubes and the cubes produced over the next 24hours.
If the ice cubes still taste stale, change the water filter.
Putting the ice maker into operation
Notes
¡ Ice cube production starts as soon as the appliance is
switched on and the freezer compartment has reached
the set temperature.
¡ As soon as the freezer compartment reaches the set
temperature, the first batch of ice cubes will be ready in
approximately 4hours.
Requirement:The appliance is connected to the drinking
water connection.
▶ For hygiene reasons, discard the ice cubes produced
within the first 24hours.
Switching on ice cube production
▶
Lift the ice maker cover upwards and press the ice
maker button
.
a The ice maker button lights up.
Note:If you press and hold the ice maker button for 3
seconds, the filter change status is reset.
Bekijk gratis de handleiding van Thermador T36FL810NS, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Thermador |
| Model | T36FL810NS |
| Categorie | Koelkast |
| Taal | Nederlands |
| Grootte | 15194 MB |