Theben RMG 8 T KNX handleiding
Handleiding
Je bekijkt pagina 53 van 87
MIX 2 series RMG 8 T / RME 8 T actuators
5.3.6 Parameter description for the blinds actuator
5.3.6.1 The "RMG 8 T basic module" parameter page
Designation
Values
Description
Relay switch delay
This parameter sets the minimum delay
between switching on two relays if
several are activated at the same time.
The shortest delay is achieved by using
the central UP/DOWN object (Obj.
247).
When switching via individual
telegrams (1 telegram per channel), the
bus running time and the sequential
processing of commands causes an
additional delay.
This can help avoid high current peaks
when devices are switched on
simultaneously
None
There is no added delay.
60 ms
100 ms
200 ms
When a relay has switched on, the next
one (within the module) can only switch
on after the set delay is completed.
The switch-on delay between the first
and last relay is calculated according to
the following formula:
(Number of channels – 1) x delay
Example:
RMG 8 T and 60 ms:
= (4 channels – 1) * 60 ms = 180 ms
Last channel switches with a delay of
180 ms.
The same applies to the first or second
extension module.
Version: May-14 (Subject to change) Page 53 of 87
Bekijk gratis de handleiding van Theben RMG 8 T KNX, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Theben |
| Model | RMG 8 T KNX |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 11185 MB |
