Thames & Kosmos Robotics Workshop handleiding

Niet gecategoriseerd

Thames & Kosmos

68 pagina's

PDF beschikbaar

Handleiding

Here are a few tips for

assembling and using the

models. Read them carefully

before starting.

A. Pay attention to the

hole alignment!

It is very important that you pay

close aention to the alignment of

the holes in the gear wheels. Make

sure that you insert the shaft pins

into the correct holes and that the

gears are oriented exactly as

shown in relation to each other

and to the model. Otherwise, the

models will not move properly.

B. The anchor pin lever

In the box, you will ﬁnd a lile

yellow tool called the anchor pin

lever or part separator tool. End A

of the tool makes it easy to remove

anchor pins from the frames. End B

can be used to pry pieces apart.

C. Gear wheels

The models will often have several

gear wheels installed in a row, or

gear train. In order for the models

to work well, these gears will have

to mesh well. Otherwise, the force

from one gear wheel won’t be

properly transferred to the next.

D. Installing batteries in

the core controller

Push the tab in and slide the

transparent cover open. This takes

some force, so an adult might need

to help. Insert the baeries

according to the indicated plus-

minus polarity. Close the

compartment by snapping the

cover back on.

E. Placing the stickers on

the CB1 core controller

Place the stickers from the sticker

sheet on the core controller in the

right spots. This will make it easier

to plug the sensors into the correct

locations.

LED 2

Microphone

USB port

LED 1

Ultrasonic sensorMotor 4

Light sensorMotor 3

Touch sensor 1Motor 2

Touch sensor 2

Control knob

DC 5V input

(2.5A or above

recommended)

Motor 1

Power switch

Hole A

Hole

Hole C

› › › TIPS AND TRICKS

Bekijk gratis de handleiding van Thames & Kosmos Robotics Workshop, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.