Thames & Kosmos Robotics Smart Machines: Tracks & Treads handleiding

Niet gecategoriseerd

Thames & Kosmos

64 pagina's

PDF beschikbaar

Handleiding

Object Near Object Far

WRITING PROGRAMS

REMOTE CONTROL MODE

The ultrasonic functionality will now be available if the

ultrasonic sensor is connected properly. The concentric

circular rings indicate the relative distance to an object in

front of the sensor. The ring lights up when an object is

detected. Closer objects light up the inner rings; objects

that are farther away light up the outer rings. Test it out

by moving an object in front of the sensor.

You can use the two slider controls (C) to directly control

the two motors on your models. Slide the slider up or

down with your ﬁnger to make the motor spin clockwise

or counterclockwise.

PROGRAMMING MODE

Press the gear icon (D) to enter the programming mode.

When you press the icon, a list of programs appears. You

can save up to 24 programs. The app comes with demo

programs preloaded in Programs 1-24. You will be using

programs 17-24 in this kit.

UNDERSTANDING THE ULTRASONIC

DETECTION INTERVALS

1. Enter Program 8, which is a blank program. The

programming screen appears.

2. The Go buon (E) runs the program. When it is pressed,

the number in the upper left (F) will start indicating the

distance to the object that the sensor is detecting.

3. After you press the Go buon, it becomes a Stop buon

(G) and the program runs. You can see in this example

that the sensor is reading a distance of “21.” This

equates roughly to a distance of 21 centimeters. Press

the Stop buon.

4. The sensor distance indicator line (H) has adjustable

ranges. Diﬀerent program segments can run in each of

these ranges. By default, there are three ranges. The

ﬁrst range marker (I) is set at 30 and the second marker

(J) at 50. This means there are four program segments

by default, which are described on the next page.

Continued on next page >>>

F G

I J

Bekijk gratis de handleiding van Thames & Kosmos Robotics Smart Machines: Tracks & Treads, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.