Thames & Kosmos Mechanical Engineering: Robotic Arms handleiding

Niet gecategoriseerd

Thames & Kosmos

40 pagina's

PDF beschikbaar

Handleiding

› › › TIPS AND PREPARATIONS

Making the test

objects

You can make these

objects and use them to

test your robotic arms.

Trying picking these

objects up with each

robotic arm.

450 mm x 2 300 mm x 1

Cutting the tube to length

You must cut the 1200-mm tube into these lengths. The

specific lengths needed for each model are indicated in

the assembly instructions for each model. You can also

write the lengths on the tubes with a pen so they are

easier to tell apart.

Tips for operating the pump

To operate all the models, you must pump up the air tank. Always set the

switch lever to the center position before pumping, so the air pressure

builds up in the tank. Pump the air pump 30-40 times. To operate the

models, move the switch lever to one side or the other. For some models, it

is easier if you remove the pump and air tank first and then reattach them

to operate the model. Pumping 30 times can operate model 10–15 times.

The carbon rod inside the pump can withstand the maximum bending

force of 4 kg. (8.8 lb.).

1 2

3 4 5

6 7

4 5 6 7

8 9

2 3

Bekijk gratis de handleiding van Thames & Kosmos Mechanical Engineering: Robotic Arms, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.