Tenda SG04E handleiding
Handleiding
Je bekijkt pagina 12 van 14
- 11 -
Q5. The PON indicator keeps blinking. What should I do?
It indicates that the ONU failed to register with the OLT. Try the following
solutions:
‒ Check the optical fiber connection: Use an optical power meter to
measure the 1490 nm signal strength to ensure that the optical power
value is within the normal range (-8 dBm to -28 dBm). Optical power
that is too low or too high will cause ONU registration failure.
‒ Check the ONU and OLT configurations: Check the OLT configura-
tion and confirm whether the ONU is required to configure authentica-
tion parameters, such as LOID. Check the list of unauthorized ONUs. If
the unauthorized ONU is found, authorize it normally and make the ONU
online.
Q6. The LOS indicator keeps blinking. What should I do?
It indicates that the ONU cannot detect the optical signal. Try the following
solutions:
‒ Check the optical fiber power: Use an optical power meter to
measure the 1490 nm signal strength to ensure that an optical power
value exists. Ensure that the received optical power is at a proper value.
‒ Check the status of the OLT optical module: Ensure that the optical
module is installed properly without damage or loose cable/optical
module. Or replace another optical module and try again.
Bekijk gratis de handleiding van Tenda SG04E, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Tenda |
| Model | SG04E |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 862 MB |
