Tenda MW5G handleiding
Handleiding
Je bekijkt pagina 8 van 48
English
02
III Connect the primary node to the internet
1. Connect the smartphone to the WiFi network of the primary node. The SSID and
password are specified on the bottom label of any node.
2. Run the Tenda WiFi App and follow the onscreen instructions to connect the
primary node to the internet.
After the primary node is connected to the internet, its LED indicator lights solid green.
IV Connect the secondary nodes to the internet
1. Place each node:
- At a high and open area.
- Ensure that the wall between any two nodes is less than two.
- Keep your nodes away from electronics with strong interference, such as
microwave oven, induction cooker, and refrigerator.
2. Power on secondary nodes, and their LED indicators light solid green. Wait for
about 40 seconds. The secondary node is connecting to another node when
its LED indicator blinks green.
3. Observe the LED indicators of the secondary nodes until their LED indicators
light one of the following colors:
4. If a node's LED indicator does not light solid green, relocate it according to step 1
in IV Connect the secondary nodes to the internet for better connection.
Done.
• To access the internet:
- Wired devices: Connect wired devices to the LAN ports of your nodes.
- WiFi-enabled devices : Connect WiFi-enabled devices to your WiFi network
using the SSID and password you set.
• If you want to manage the network anytime anywhere, tap and use your
account to log in.
Solid green Good connection
Solid yellow Fair connection
Q1: How can I remove a node from my WiFi network?
A1: Tap the node on the Tenda WiFi App, tap ... in the upper-right corner and
choose Delete.
Note: Removing operation restores the node to factory settings.
Q2: Can I add another new set of nodes to expand my network coverage?
A2: Yes. Run the Tenda WiFi App, navigate to Settings > Add nova, and follow
the on-screen instructions.
Q3: How to restore my network to factory settings?
A3: With your nodes powered on, hold the Reset button of your primary node
down using a sharp item (such as a pin) for about 6 seconds, and release it
when the LED indicator blinks fast. Your network is reset successfully when
the LED indicator lights solid green then blinks slowly again. And all nodes
are restored to factory settings.
Q4. My 2.4 GHz WiFi-enabled devices, such as a home security camera,
cannot connect to my nova WiFi network. What should I do?
A4: Try the following solutions:
Step 1 Connect your smartphone to your nova WiFi network.
Step 2 Run the Tenda WiFi App, tap Settings, Smart Assistant, and Enable.
Your smartphone connects to the 2.4 GHz WiFi network.
Step 3 Use the smartphone to set up your 2.4 GHz WiFi-enabled device
guided by the App of the camera.
FAQ
Ports and buttons are on the back (example: Mesh5)
* Appearances vary with models, please connect with the model you actually purchased.
Power outlet
Modem
Or
Ethernet jack
Internet
Solid red Disconnected
Bekijk gratis de handleiding van Tenda MW5G, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Tenda |
| Model | MW5G |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 5493 MB |
Caratteristiche Prodotto
| Kleur van het product | Wit |
| Breedte | 91 mm |
| Diepte | 91 mm |
| Hoogte | 93 mm |
| Gebruikershandleiding | Ja |
