Supermicro SuperServer AS-3015MR-H10TNR handleiding

Niet gecategoriseerd

Supermicro

94 pagina's

PDF beschikbaar

Handleiding

Chapter 4: Motherboard Connections

Onboard TPM 2.0 Enable/Disable

Use JPT1 to enable or disable support for the onboard TPM 2.0 module. The default setting

is Enabled.

Watch Dog Timer

Watch Dog Timer (JWD1) is a system monitor that can reboot the system when a software

application hangs. Close pins 1-2 to reset the system if an application hangs. Close pins 2-3

to generate a non-maskable interrupt (NMI) signal for the application that hangs. Refer to

the table below for jumper settings. The Watch Dog Timer must also be enabled in the BIOS.

TPM 2.0 Enable/Disable

Jumper Settings

Jumper Setting Denition

Pins 1-2 Enabled (Default)

Pins 2-3 Disabled

Watch Dog Timer

Jumper Settings

Jumper Setting Denition

Pins 1-2 RST (default)

Pins 2-3 NMI

Open Disabled

CPU Throttle when PWR_Fail

Jumper JPO1 can enable the CPU Throttle mechanism to protect the processor from damage

due to excessive heat. This is a safeguard for preventing damage to the system. When an

overheating condition occurs, thermal throttling kicks in. Three options are available to handle

overheating: Power o󰀨, CPU Throttle – decrease CPU frequency to the minimum (800 MHz),

and Performance – do nothing.

CPU Throttle when PWR_Fail

Jumper Settings

Jumper Setting Denition

Pins 1-2 Enabled

Pins 2-3 Disabled (Default)

SATA Select

Jumper Settings

Jumper Setting Denition

Pins 1-2 Auto

Pins 2-3 SATA (CN1)

Open NVMe

SATA Select

The JSATA1 jumper is used to select the function of the NVMe/SATA connections at J22/J23.

Bekijk gratis de handleiding van Supermicro SuperServer AS-3015MR-H10TNR, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.