Supermicro SuperBlade SBI-420P-1T3N handleiding

Niet gecategoriseerd

Supermicro

94 pagina's

PDF beschikbaar

Handleiding

SuperBlade Server SBI-420P-1(C2/T3)N User's Manual

Appendix A

BIOS POST Codes

A.1 BIOS POST Messages

During the Power-On Self-Test (POST), the BIOS will check for problems. If a problem is

found, the BIOS will activate an alarm or display a message. The following is a list of such

BIOS messages. Not all options may be supported.

BIOS POST Messages

BIOS Message Description

Failure Fixed Disk

Fixed disk is not working or not congured properly. Check to see if xed disk

is attached properly. Run Setup. Find out if the xed-disk type is correctly

identied.

Stuck key Stuck key on keyboard.

Keyboard error Keyboard not working.

Keyboard Controller Failed Keyboard controller failed test. May require replacing keyboard controller.

Keyboard locked - Unlock key

switch

Unlock the system to proceed.

Monitor type does not match

CMOS - Run SETUP

Monitor type not correctly identied in Setup

Shadow Ram Failed at o󰀨set:

nnnn

Shadow RAM failed at o󰀨set nnnn of the 64k block at which the error was

detected.

System RAM Failed at o󰀨set:

nnnn

System RAM failed at o󰀨set nnnn of in the 64k block at which the error was

detected.

Extended RAM Failed at o󰀨set:

nnnn

Extended memory not working or not congured properly at o󰀨set nnnn.

System battery is dead -

Replace and run SETUP

The CMOS clock battery indicator shows the battery is dead. Replace the

battery and run Setup to recongure the system.

System CMOS checksum bad -

Default conguration used

System CMOS has been corrupted or modied incorrectly, perhaps by an

application program that changes data stored in CMOS. The BIOS installed

Default Setup Values. If you do not want these values, enter Setup and enter

your own values. If the error persists, check the system battery or contact your

dealer.

System timer error The timer test failed. Requires repair of system board.

Real time clock error Real-Time Clock fails BIOS hardware test. May require board repair.

Check date and time settings

BIOS found date or time out of range and reset the Real-Time Clock. May

require setting legal date (1991-2099).

Bekijk gratis de handleiding van Supermicro SuperBlade SBI-420P-1T3N, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.