Supermicro Blade SBI-621E-1NE38 handleiding
Handleiding
Je bekijkt pagina 17 van 61
30 31
Chapter 2: Installation and Setup Chapter 2: Installation and Setup
6. Press all four rotating wires outward and make sure that the heatsink is securely latched
to the CPU socket.
7. With a t30-bit torque driver set to a force of 8.0 in-lbf (0.904 N-m), tighten all PEEK nuts
in the sequence of "A", "B", "C", and "D" with even pressure. Do not exceed the torque
specications when tightening the screws.
8. Examine all corners of the heatsink to ensure that the PHM is rmly attached to the
CPU socket.
Latched State
4. Align PEEK nut "A" (next to the trianglular pin 1 on the heatsink) with threaded fastener
"a" on the CPU socket. Then align PEEK nuts "B", "C", "D" on the heatsink with
threaded fasteners "b", "c", "d" on the CPU socket.
5. Once aligned, gently place the PHM on the CPU socket, making sure that each PEEK
nut is properly attached to its corresponding threaded fastener.
3. Check the rotating wires (1, 2, 3, 4) to make sure that they are in the unlatched position.
A, B, C, D:
PEEK Nut on the Heatsink
a, b, c, d:
Threaded Fastener on the CPU socket
A
C
D
B
a
b
d
c
Side View
Top View
Unlatched State
Rotating Wire 1
PEEK Nut
Torque set to set to a force of 8.0 in-lbf (0.904 N-m)
Bekijk gratis de handleiding van Supermicro Blade SBI-621E-1NE38, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Supermicro |
| Model | Blade SBI-621E-1NE38 |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 19299 MB |
