Sungrow WiNet-S handleiding
Handleiding
Je bekijkt pagina 41 van 49
--End
4.3.3 Turn off module AP hotspot
The AP hotspot can be turn off in two ways: if you are near the module, you can short press the
button twice to complete the operation; if you are at a distance, you can perform the operation
remotely via the iSolarCloud App. For specific steps, please refer to 4.3.3.1 Short press the
button twice and 4.3.3.2 On iSolarCloud App (Remotely).
4.3.3.1 Short press the button twice
Short press the button twice to turn off the module AP hotspot.
ln the following scenarios, the hotspot cannot be turned off:
• If the device is in networking mode, the hotspot cannot be turned off.
• If the WiMeter device has been connected, the hotspot cannot be turned off.
The hotspot will turn on automatically after the device quits the SmartConfig mode. You can
then press the button twice to turn it off again.
After short pressing the button twice, you can log in to the iSolarCloud App remotely and
set "AP hotspot enable switch” to “Open” to turn on the hotspot. Then, you can press the
button twice to turn off the hotspot again.
4.3.3.2 On iSolarCloud App (Remotely)
Step 1 Log in to the iSolarCloud App, choose the plant to which the WiNet has been added, and
go to "Device".
Step 2 Select the WiNet device and tap "Settings".
Step 3 Choose “Common Parameters”, and set “AP hotspot enable switch” to “Close”. Then, tap
“Confirm”.
User Mannul
4 Commissioning and Maintenance
35
Bekijk gratis de handleiding van Sungrow WiNet-S, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Sungrow |
| Model | WiNet-S |
| Categorie | Niet gecategoriseerd |
| Taal | Nederlands |
| Grootte | 4549 MB |
