Handleiding
Je bekijkt pagina 35 van 40
35
Built-In Top Unit with Pilots (Main Burners Not Shown)
On units with battery powered ignition, there are no top burner pilots. There are
top ignitor electrodes in the same location as the top burner pilots. This ignition
system requires one (1) 9 volt alkaline battery for operation. The battery is
housed in an enclosure underneath the switch panel cover. It is recommended
that you check and/or replace the battery at least once per year.
Built-In Top Unit with Battery Ignition (Main Burners Not Shown)
Access the battery for periodic servicing as follows:
• Remove the burner grates and top burner knobs from the unit.
• Raise the main top by lifting it by the front edge.
• Use a hex driver to remove four (4) screws from the switch panel cover.
• Gently lay the switch panel cover over to the left.
• Use a hex driver to remove one (1) screw from the battery enclosure.
• Check and/or replace the battery as recommended.
• Reinstall the battery enclosure.
• Reinstall the switch panel cover.
• Lower the main top and replace the grates and knobs.
9V
Top Ignitor
Electrodes
Switch Panel Cover
Spark Module
Battery Enclosure
Top Burner Pilots
Pilot Adjustment
Manifold Pipe and
Burner Valves
Insert wiring diagram (180-
6Cxxx) in this space. All
remaining sections are unchanged
and shifted one page rearward.
ELECTRIC SURFACE UNITS
MOUNTING THE BUILT-IN TOP UNIT
Place unit in cabinet opening with the knobs, on the right side. Raise the top by lifting
upward on the front edge of the main top. Secure unit to top of cabinets with four No.
8 screws through holes provided in the top flanges of the burner box. Make electrical
connection. Electrical connection should conform to local requirements and codes.
POWER CONNECTIONS TO APPLIANCES
We suggest that you have the dealer where you purchased your new range install it
or have him arrange installation by a qualified electrician. Installation must conform
with local codes. In addition, installation must conform with the National Electric Code
NFPA70 latest edition.
WARNING–Be sure electric power is OFF at the fuse (breaker) box until the unit is
installed and ready to operate. See appliance rating plate for maximum
K.W. and amperage rating.
35
Built-In Top Unit with Pilots (Main Burners Not Shown)
On units with battery powered ignition, there are no top burner pilots. There are top ignitor
electrodes in the same location as the top burner pilots. This ignition system requires one
(1) 9 volt alkaline battery for operation. The battery is housed in an enclosure underneath
the switch panel cover. It is recommended that you check and/or replace the battery at
least once per year.
Built-In Top Unit with Battery Ignition (Main Burners Not Shown)
Access the battery for periodic servicing as follows:
• Remove the burner grates and top burner knobs from the unit.
• Raise the main top by lifting it by the front edge.
• Use a hex driver to remove four (4) screws from the switch panel cover.
• Gently lay the switch panel cover over to the left.
• Use a hex driver to remove one (1) screw from the battery enclosure.
• Check and/or replace the battery as recommended.
• Reinstall the battery enclosure.
• Reinstall the switch panel cover.
• Lower the main top and replace the grates and knobs.
Bekijk gratis de handleiding van Summit TTM1307BKSW, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Summit |
| Model | TTM1307BKSW |
| Categorie | Fornuis |
| Taal | Nederlands |
| Grootte | 5509 MB |
