Handleiding
Je bekijkt pagina 34 van 40
Flexible Connectors - If the gas range/oven is connected to a gas supply with a metal
exible connector, move the range/oven with CAUTION for service or cleaning. Flexible
connectors are not intended for repeated bending. Do not allow cleaners to make contact
with exible connectors.
The connector and its ttings are designed for use only on the original
installation and are not to be reused for another appliance or at another
location. Connectors must comply with ANSI Z21.24.
BUILT-IN TOP UNITS WITH NO POWER CORD
If your built-in top unit is not equipped with a power cord, the unit operates by standing
pilot lights or a 9 volt battery powered ignition system. These units must be set up and
maintained as outlined below.
Adjust the size of the top pilot ame until there is only a slight tip of yellow on the ame
as described in the ALIGNMENTS AND ADJUSTMENTS section of the user manual.
The adjustment screw is located on the side of the manifold pipe.
GAS RECESSED WALL OVEN
MOUNTING THE BUILT-IN TOP UNIT
Place unit in cabinet opening with the valves on the right side. Raise the top by
removing top burner valve knobs, and lifting upward on the front edge of the main top.
Secure unit to top of cabinets with four No. 8 screws through holes provided in the top
anges of the burner box.
The gas pressure regulator supplied must be used with this unit. If it is necessary to
convert this unit from use with natural gas to L.P., or L.P. to natural, see “To Convert
and/or Adjust” in “Alignments and Adjustments” section.
The installation must
conform with local codes. In the absence of local codes, the National
Fuel Gas Code Z223.1 latest edition.
A MANUAL GAS VALVE MUST BE INSTALLED IN AN ACCESSIBLE
LOCATION IN THE GAS LINE EXTERNAL TO THE UNIT FOR THE
PURPOSE OF TURNING ON OR SHUTTING OFF GAS TO THE UNIT.
34
ELECTRICAL GROUNDING
INstructIoNs
This appliance is equipped with a three prong
grounding plug for your protection against
shock hazard and should be plugged directly
into a properly grounded receptacle. Do not cut
or remove the grounding prong from this plug.
INSURE PROPER
GROUND EXISTS
BEFORE USE.
Bekijk gratis de handleiding van Summit TTM1307BKSW, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.
Productinformatie
| Merk | Summit |
| Model | TTM1307BKSW |
| Categorie | Fornuis |
| Taal | Nederlands |
| Grootte | 5509 MB |
