Structural Concepts Oasis HECO57R handleiding

Koelkast

Structural Concepts

31 pagina's

PDF beschikbaar

Handleiding

MAIN POWER SWITCH - START-UP / TEMPERATURE CONTROLLER / LIGHT SWITCH

1. Main Power Switch - Start-Up

 Remove the front grille simply by lifting up and

off (no screw removal required).

 Turn on the main power switch. Main power

switch is on the left hand side of unit (accessible

after front grille has been removed). Evaporator

coil fans, and compressor motor (for units with

self contained refrigeration) will energize.

 From the front of the case, raise the deck pans

and check to see that the coil fans are all

functioning properly. Caution! Rotating fan

blades are sharp. Do not place fingers near

rotating blades!

 Replace front grille in reverse order it was

removed.

2. Temperature Controller

 The case temperature is set at the factory,

(supply air is set for a case temp at 5 °C / 41 °F

as as determined by the case size.

 The temperature is controlled by a thermostat.

 See illustration at right for thermostat location.

 If a temperature setting change is required,

refer to the CAREL® TEMPERATURE

CONTROLLER INFORMATION section of this

operating manual.

Main Power Switch

--- Case Front Access After Front Grille Removed (Model HECO37R) ---

3. Light Switch At Header, Upper-Left

 Whether fluorescent or LED lights are used on

case, switch is at header, upper-left (as shown

immediately below).

 Turn on light switch.

 All lights should come on at the same time.

 Fluorescent bulbs may require a short warm-up

period; initially, new fluorescent bulbs may be

slightly dim or flicker.

 Whether fluorescent or LED, if lights do not turn

on, check plug connections

--- Carel Temperature Controller ---

--- View of Upper Left Header ---

Light Switch

Bekijk gratis de handleiding van Structural Concepts Oasis HECO57R, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.