Structural Concepts Oasis FSIB4R handleiding

30 pagina's
PDF beschikbaar

Handleiding

Je bekijkt pagina 23 van 30
23
TROUBLESHOOTING - TO BE PERFORMED BY TRAINED SERVICE PROVIDERS ONLY
CONDITION TROUBLESHOOTING
Case Not
Lining Up
See POSITIONING & ALIGNING / ADJUSTING LEVELERS / LOCKING CASTERS IN
PLACE section in this manual for instructions on properly aligning case (alongside other
cases) and adjusting levelers.
Water Is On
The Floor
Caution! Water on flooring can cause much damage! Until cause is determined (and
repaired), follow these procedures:
Use wet-dry vacuum (or mop & bucket) to remove standing water.
Use catch pansfor water to drain into. Swap out regularly until case has drained.
When power to case is restored, condensate pan should function properly and water
will no longer overflow onto flooring.
Note: See Drain, Hose and Bracket Placement Illustrations sheet in this manual for
views of different condensate systems used in display cases.
Check that the drain trap is free of debris.
Check that the drain hose is correctly positioned over condensate pan (or floor drain, for
remote units).
Check store conditions.
To prevent condensation in NSF/ANSI Type I environments, maximum conditions are
to be 55% relative humidity / 75° Fahrenheit.
For NSF/ANSI Type II environments, maximum conditions are to be 55% relative
humidity / 80° Fahrenheit.
If you are unsure if your unit is classified as NSF/ANSI Type I or Type II, see tag next
to serial label on your case.
Check condensate pan float for proper operation (electric condensate trays).
Check that condensate pan is properly plugged in or connected.
Caution! Wicking material (if any) on your particular hot gas loop condensate tray may
be dirty or worn and need replacement.
Slide condensate package out from under unit.
After refrigeration system has been carefully slid out, replace wicking material with
new. If wicking material is not available, contact Structural Concepts. See toll-free
number at last page of this operating manual.
See CONDENSER PACKAGE LAYOUT (SELF-CONTAINED UNITS ONLY) section
in manual for wicking material illustration.

Bekijk gratis de handleiding van Structural Concepts Oasis FSIB4R, stel vragen en lees de antwoorden op veelvoorkomende problemen, of gebruik onze assistent om sneller informatie in de handleiding te vinden of uitleg te krijgen over specifieke functies.

Productinformatie

MerkStructural Concepts
ModelOasis FSIB4R
CategorieNiet gecategoriseerd
TaalNederlands
Grootte13727 MB